CamcoRhino Steerable Wheel Kit for 28 & 36-Gallon Rhino RV Tote Tanks - Features No-Flat Front Steerable Wheels, 24" Tow Bar & More RV Accessories (39011)

I broke my flush fitting off my camco portable waste tank . This new flusher installed with three provided screws . Easy to install and now my tank is like new again.

The hose that came with my blue boy was very lightweight and cheap. It developed pin holes by the 2nd or third time I used it. I tried repairing it. But it was a disaster. It came apart in pieces. My regular black water hose is a Rhino and works great! The first time I used this to transfer black water to the blue boy and then to the septic was easy clean! It's worth the couple extra dollars to get this heavy duty product!

Works as expected.

It looked like a simple installation but as typical of my projects I ran into a little glitch...not too serious but a little annoying. The base of the two stand uprights are supposed to lay across the top of the bumper and extend back a little way under the camper body and then the u-bolts go over the part lying across the bumper and secure it to a steel plate under the bumper. This assumes that the bumper either sits far enough back for the upright to have enough room for the u-bolt to fit before contacting the rear of the RV or the bumper is low enough that the upright will lay across the bumper and extend under the RV. On my trailer the top of the bumper was about even with the bottom of the trailer and close enough that there barely was enough room for the u-bolt to fit behind the bumper. With the rear u-bolt in place it was so close to the end of the upright that it would slip off while tightening the bolt. My solution was to install a bolt on top of the upright near the end to serve as a stop to keep the bracket from sliding off when tightened. See attached pics. That worked fine. The black paint on the steel plate that goes under the bumper was flaking off in places so I am sure I will have to touch that up to prevent rust. A couple of cam buckle straps were provided but I could not get them to hold as firmly as I like so I will be adding some better ratchet straps. Overall this tote carrier seems sturdy and well made and I am satisfied with it.

If you're going to purchase a holding tank why wouldn't you want to have this gauge? Make the purchase.

Perfect size and connections for emptying into a portable tank

Makes transporting a full tank to the waste dump a breeze.

I bought this guage so I could tell when my Campco tote was getting full. I have used it for two trips to the dump station. The first time the tank was not full enough to activate the guage. The second time i could see the guage moving around but not rising. The tank still didn't have enough fluid to raise the float. I'm sure it will work fine with a fuller tank. Installation was very easy. To vent the tank I just pulled up on the guage housing to open the vent opening. To close the vent just push the housing down. I think the price is a bit much, but since this tank and float will be used more often than I would like it was a fair price to prevent filling issues. I would buy again.

Work awesome

Had to get these to replace original wheels that fell apart after three years. Had to tow unit to dumping station at speeds between 3 or 4 ou to ten miles an hour. Dumped unit on average every second weekend de\pending how many visitors we had - so about twelve to fifteen times per season. Road is mainly gravel with some old paved sections. Did my best to avoid any really rough patches and pot holes. Especially where these wheels would pass over. I’m surprised that they fell apart so quickly. Hoping these will last longer. (Cross fingers and toes) also looking at getting the proper tool to tow the unit with the wheels off of the ground. Will definitely keep a closer eye on them this time.

tres utiles

Exactly what i ordered. Good quality.

I have the 28 gallon Rhino tank, bought without the wheel kit. I found it very heavy to move around, doing my back no favours. So, even though the wheel kit was expensive, decided I had to go with it. The kit is very well built, quite robust. The only complaint I had was one of the wheel retainer clips was missing. But, a quick email to Camco resulted in a speedy reply. They sent me a new clip, which was received quickly. So, a high quality product and great customer service, just wish it'd been less $.