ROMEO1 SHROUD KIT

Nice shroud and durable. Price is a little high for a single piece of metal but its the brand quality that you pay for. Fits perfect on my p320 xCompact with the Romeo1 Pro. Would recommend

Nice protector to my red dot.

Installation is easy and the added protection to the Romeo 1 is worth every penny. I did also buy a in/lb. torque driver through Amazon to ensure proper torque on the screws.

As stated in another review, this is made of steel. Even Sig's website states it as such. That said, it is better at doing the job than aluminum. Gotta protect your investment! BEWARE though. If you have a factory-installed Romeo1Pro it would be best to use the existing screws that came with it rather than the screws provided with this shroud. The screws on my pre-installed Romeo1Pro are the same length as the provided screws, HOWEVER, the thread pitch appears to differ from each other. Rather than risk stripping the threads on my slide using the new screws, I just used the original ones that came with my Sig. 200 rounds through, no problems at all. I just wished it came with the big sight protector like the one's that are included with the Romeo1Pro if you bought it separately, otherwise it'll actually be worth the price tag.

Feels very solid & it fit on slide great. One issue I had was the thread locker/paste they put on the screws made it very hard to screw down. Had to remove the pre installed thread locker and apply blue loctite. Also it would be nice if they include installation instructions with torque specs.

Fits perfect... Looks awesome... SIG is perfect Perfection.... I have the cheap knock off but the fit and finish cannot compare to the Sig...

Works just fine with the Romeo 1 Pro, but take the time to center the shroud on the optic. The holes are a bit oversized vs the screw diameter and since the Romeos lack locating lugs like an RMR , there is play. I put this on a Sig Legion RXP with Romeo 1 Pro cut and had no issues. I did use the screws that came with the pistol and torqued to 30in lbs per the optic instructions. I felt there was plenty of thread engaging with the original screws. For what it’s worth, the same item on the SIG website specifically says it works with the Romeo 1 and Romeo 1 Pro only. Not sure why there is so much confusion.

First off. This shroud is made of "STEEL" and not of aluminum like described. Which is a good thing. Just remember when installing to put your Romeo and shroud together and line up holes while sliding both into machined dovetail on slide at the same time. It's a little tricky but will fit. Took me a few tries. It's been reported that using this shroud, It will cover up some of the front sight when aligned with rear. I did not experience this at all. My factory RX slide came with suppressor height installed sights. I experience clear and unobstructed sight alignment. I would purchase a "laser bore sight cartridge" to check iron sight alignment and Romeo 1 at a factory set 25 yards zero POA/POI. I hope this helps, and enjoy this purchase.

Best seller