FEBRYTOLD 12 Pcs CV Boot Clamp, 6 Pcs Small and 6 Pcs Large Stainless Steel Universal Adjustable Stainless Steel Drive Shaft CV Boot Clamp

This kit works perfectly to retain my cv boot which came without new clamps.

Good quality clamps . U need the crimp tool

Measure your old clamp width beforehand., or measure the band groove in your replacement boot. The boot I used, and some other boots I had on hand, needed a smaller width clamp, around 6.5mm. The big one here is 9mm and was definitely too wide. They are heavy duty and I will just keep them on hand.

The clamp was the same width and thickness as the original clamp, and it seems very well made. The only difference was that the original clamp had the 3 hooks/teeth pointing away from the boot and this one has the 3 teeths pointing to the cv boot. This was not a problem for my car because the boot is very thick where the hooks are touching it. In order to protect the boot from the hooks, I cut a small piece of bicycle tire I was planning to place between the teeths of the clamp and the boot, but I did not have to use it. I replaced a loose clamp, so I only took the car tire off for this repair. Removing the old clamp was easier than I expected by inserting a screwdriver in the clamp tightening loop and rotating until the clamp hooks disengaged. Installing the new clamp in such a tight space was very easy and effortless by using a small 4" aftermarket tool similar to the one sold by Toyota. For the tool, I used a 13 mm socket to tighten the clamp.

pretty good quality.

Perfect performance - auto dealer parts house stated that this would not work. Yes, and better than the product and cost from them. Go for it and do not waste your time there. I would purchase again. In fact I installed these myself (DIY home mechanic) and still providing excellent service. I should provide photos but I can always update and provide. We need good quality and decent prices sometimes and I thank all who have helped during my research.

The bend at the crimp-point did not allow it to be crimped. I had to remove it, start the crimp with a pair of needle knows pliers, so the crimper would not slide off without crimping it. I also had to form the end to the curve of the boot, or would not stay on until I could crimp it. BUT... after doing all that... it did crimp, and it has been holding for a few weeks without issue.

Didn’t expect much except for them to work but these axle boot clamps are super thick and tough. Used the toyota crimping tool to close it up easy. Warning though, the first one I tried closing up all the way and it broke open(my fault). So this not like an oem clamp where the inside of the clamping notch closes until touching, maybe halfway until touching and you’ll see it’s tight enough imho… God bless fellow diy’ers!

منتج ممتاز