SSF-6 56% Silver Solder Brazing Rods (4 rods)

WORK REALLY WELL!

Added a stainless steel plate to the bottom of my steel marine fuel tank. Tip: we overlapped the pieces being weld by 1/4" to save time getting them to fit perfect (old bottom had rusted out) but big mistake because that 1/4" overlap we welded sucks in way too much SS6. Use an edge to edge or edge to flat surface weld. and with 70,000 psi strength it will still be very strong. We used map gas. Give time for temp to melt stick so you don't ball up too much solder too early and waste it. Apply flux only where you want solder then be patient and wait for it to melt and it will flow to where the flux was applied. Great product!

While there is a bit of a learning curve with this, once you figure it out it works as intended. Very happy with it.

After an email to seller, no response as to its ability to span gaps in sheet metal as an alternative to MIG welding. Tried it anyway, hard lesson - very difficult to get it to bridge a 1/16" gap on good old British sheet metal body panels (Sunbeam Tiger). When you can keep the "weld" from blowing-out, the joint is strong both before and after grinding the seem. Sounded like a DIYers' dream, but ultimately disappointing and cost prohibitive.

Product returned, no fault of manufacturer.

Great stuff

Good stuff!!!