Flowmaster 15371 Exhaust Tip 4 Inch Rolled Angle Cut Polished 304 Stainless Steel Fits 3 Inch Tubing Weld On

This exhaust tip is really great. It has the look and character to complement my car that already has Flowmaster mufflers. The nature of this exhaust tip adds an aggressive tone to the vehicle due to its two direction outlet. The 4" outlet enhances the looks since it is highly polished. This tip is very short, (only 4") so in order to make it visible, I had to have it welded to a pre-existing exhaust tip that way this tip protrudes about 2" from the rear bumper. The look is amazing, I can finally say I found the exhaust tip I was looking for. Definitely worth it.

This did not fit a 3-inch outlet (or 4-inch) and furthermore it was not a "Weld-On. It had a bolt and clamp. Very small. Returned.

Its a nice looking tip, but it does seem to rust a little too easy. I drive my car year round and live in a state that loves to put salt on the roads for the people that don't know how to drive.

Put these on my 2015 SS/RS CAMARO with Flowmaster Super 40 mufflers. 3 inch in 3 inch out. Looks a whole lot better than factory tips and even changed the tone a little. Probably because it is 4 inches in diameter verses factory which has a 2.5 inch outlet plus bevels which made them 4 inches. A great tip and worth the money. Definitely recommend.

I had to have two these to pare with my Flowmaster 42583 80 Series Muffler - 2.50 Offset IN / 2.50 Dual OUT - Aggressive Sound . looks mean and it adds lil deeper tone to the exhaust note when you accelerate.

not sure how to hook it up, did not come with instructions, looks nice but it is sitting on my garage floor

Installed on a 1999 BMW 540i with new exhast and looks very nice. Nice finish although depending on the area being used in may be prone to surface rust, but cleans up easily with fine steel wool....could be a little longer, but works well ..

Put this on some Borla pro XS mufflers. Took off the factory 3.5" tips and factory mufflers on my 2012 Durango. From what I have heard on other Hemi's with Borla Pro xs mufflers, these do kind of add a "Tuba" deep tone (good) to the exhaust. Its also nice to extend them over the rear bumper (have them weld an extension on there) so the flow-master name shows looking down on them. Will update after a few washes and once it starts snowing here in terms of rust. Flowmaster 15371 Exhaust Tip - 4.00 in. Rolled Angle Polished SS Fits 3.00 in. Tubing - weld on

These tips look and sound awesome! Would highly recommend them, very mean looking.

Excellent item with high workmanship