14610 10-Pack (10 Pairs) Retrofit C Clips Accessory - for 5 or 6 in. Traverse

These worked as expected. You may find that you need to pry the clip open a bit in order to get them wedged onto your existing can. I also did not feel the need to take the time to attached them with the provided screw. The friction mount seemed to work well enough.

I used it to install retrofit LED lights w/trim. Worked great. The screw isn't necessary since the LED lights are lightweight and the clips are very tight. That's a good thing because it's near impossible to screw them into the housing. My biggest complaint is that they come in a 10 pack. I have 2 leftover, and at $4 each that's a waste.

These did the trick - replaced the broken tabs in our can lights perfectly. The original can light units had the tabs "bent in" by the electrician. When we went to update to the Feit Electric LED retro fit units, the original tabs broke off when trying to bend them back out. These little units solved that issue.

This are definitely a life saver if you are converting to LED lights. What I did not know at the time is that you can clip them on rather then screwing them down to the container. This allow me to quickly move through the project.

if you are replacing can lights with the retrofit LED this maybe just what you need. worked perfectly for us. more expensive than I'd like but i found no cheaper suitable product.

Used to help convert existing pin based compact fluorescent can lights with built in ballast to instead hold an LED light. The clips worked well and made the switch easier as the existing reflector was held in by a screw at the top.

These worked great! So glad I found them. My new LED lights hang tight in the cans because of these clips. Not sure what I would have done without these!

Very timely product. Makes LED trim conversions a snap when the recessed cans do not have the necessary mounts.