BIGTREETECH Upgrade PI TFT50 V2.1 TFT LCD Display DSI 800x480 for Raspberry Pi 4 3 2 Model B RPi 1 B B+ A A+ 3D Printer Controller (5in Capacitive Touch Screen)

I bought two of these for my Voron printers. I could have gotten by with the 4.3" screen which is still pretty large but I went with the 5" on both. They mount at about a 45 degree angle and I had to use larger feet on one printer to keep it off the desk. I don't mind the angle or the elevated feet.I found some stl files for a case/mount for them and printed that. The included cable is way too short unless you plan to mount the pi to the back of the screen. (which wouldn't work for my mount) I had to order a longer cable. The packaging was nice. The little protective stickers on the screw holes were a little difficult to remove but kept dirt and things out of holes which is nice.There is a switch on the screen in case you need to change the orientation. (flip the image over) The touch aspect works great. It seems really accurate and I didn't have to do any tuning routing to get it to respond and work well. I use the screen a lot, even more than I expected to.

I use this to run klipperscreen and I am not disappointed. Works great, even when the screen goes to sleep, it comes back up with just a touch. Wonderful screen. Looks great.

Awesome little display, I use it in my 3D-Printer and it's amazing. Brilliant colors and easy installation. BTT is way ahead of their time, keep it up, guys.

Not much to say, except it bright, clear and the touch screen always works. I keep buying it for all my projects connected to a Raspberry Pi. Not the cheapest solution but you get what you pay!

One end of the cable provided does not have the reinforcement and simply slips out of both the pi and the screen so I have to order a cable to even see if this thing works.Edit: works fine with Pastall Raspberry Pi Camera Cable, 6pack 15 Pin (15cm×2pcs/30cm×2pcs/50cm×2pcs) FFC Ribbon Flexible Flat Cable for Raspberry Pi Module Camera adding a star back

Updated my Ender-3 from Marlin to Klipper firmware. The basic LCD was not cutting it for me so I upgraded to this screen. I have a RPi4 behind it and works well with Klipper screen. This is perfect!

I originally bought two of these to go with the two Voron 2.4 3d printer builds I was working on. The first one worked flawlessly, but the second one did not respond to touch. It was easy to troubleshoot because I could just simply swap the screens on the printers to confirm. So I returned the second one and bought another, which sortof works, but not anywhere near as well as the first one. About half of the time it seems fine, but the other half of the time it is either unresponsive to touch or the touch is way off in terms of accuracy, which is important on such a small screen. I am going to try to contact customer support and see if they will replace, otherwise Ill have to go through amazon again. Will update if customer service lives up to their job.

Works great. Had a issue with my first display and the seller contacted me and replaced it. Extremely impressed. I would definitely recommend this seller!