Bohning 1309 Ferr-L-Tite by Bohning

Fait le job

Er kann ja für irgendwas gut sein, aber für Pfeilspitzen sicher nicht. Alle drei geklebten Spitzen haben sich recht leicht gelöst, normale Zielmatte.Es gibt deutlich bessere Heißkleber, wie den, der im Geschäft (robbow) verwendet wurde. Die Spitzen halten bis heute.Oder wenn man die Spitzen f<r die Ewigkeit kleben möchte, dann Schwanheimer. Der hält alles aus.

No lo probé Lo perdí pero es bohning simplemente es la mejor marca para digamos todo el ecosistema de una flecha

Works well, I enjoy the fact that the heat I give it from a mini torch makes it soft and easy to transfer to components but doesn't turn it into a liquid state. Great control, minimal mess, super adhesion.

I'm really impressed with this hot melt. I have had serious problems getting inserts to stay in Victory arrows when using 2 part epoxy, and an even worse time getting iron will collars to stick to the outside of the shaft. I was having to sand, scuff, clean etc. etc. to keep my components in place with epoxy.Enter this hot melt. This stuff is awesome and has held up great on a dozen Victory arrows. For best application I get the insert warm and heat the hot melt with a candle or torch until it's as thin as possible without dripping off the end of the stick. Put the insert in quickly while spinning slightly and you're done. I dip the end of the arrow into some ice water and then give 5 minutes or so to fully set up and they're good to go. The arrows have been shot into block targets, bag targets and Reinhart 3d targets and nothing has budged. I'll be using this from now on.