DIN Rail Mount for Raspberry Pi (3-Pack)

I needed to mount an RPi on a DIN rail but needed the space that most of the RPI din mounts take, this one mounts the RPi at 90 degrees to the DIN rail so it takes up a very narrow space. GREAT!!!

These are good, but somewhat expensive. Still, I use them to keep my RPi boards up and out of the way while I work. Well made and sturdy; I wish they were just a little less costly.

Arrived as promised. Great Product.

Well made, solid on the rail. Very good overall.

I had to slide it off of an aluminum DIN rail because the clamps wouldn't open and it was going to bend the rail. I wanted to use them for project Pi's but that was a complete deal breaker. Had to send them back.

These are awesome to add raspberry pis to your DINrails. I've used the for the 3A+ B 3B+ and 4B. Great plates I got 100 of them no issues!

I really like these; they were just what I wanted and perform the job well.I only have three complaints:1. The plastic DIN clip is quite strong. A bare DINrPlate (no Raspberry Pi mounted to it) will come off easily enough by using a flathead screwdriver to pry the clip. But with a Raspberry Pi mounted, the slot on the clip is obstructed, making it rather difficult to remove the DINrPlate from the rail.2. This might only be a fluke, but... I ordered two sets (each of which was shipped from different Amazon warehouses, in case that matters). One set appears slightly warped and wrinkly, the edges are bowed inward slightly, and the color tone is slightly more grey-ish than the other set -- it's as if the DINrPlates were somehow exposed to extreme heat that caused the plastic to react by shrinking. The other set is straight and flat. However, the Raspberry Pi boards mounted to them fine, and the overall appearance wasn't terrible, so I kept them so I could finish my project.3. The integrated standoffs would have been better if they had embedded metal studs with machined threads, rather than having to manually twist coarse-thread screws into the plastic directly. As it is, you can't add your own standoffs for things like HATs and other peripherals, unless you carefully bore threads into the plastic yourself (which I did). Or better yet, instead of integrated standoffs, holes to allow me to use my own standoffs. But this isn't a deal-breaker.Lastly, I feel like they're a bit over-priced for what they are. However, I'm mostly happy with these overall, and I would definitely buy them again.

I've ordered these 3 times now for use in a din rail mounted raspberry pi cluster and these are a treat. I modified them by removing the plastic standoffs and widening the holes so I could accommodate the POE hat and that was very easy to do with a drill and pair of flush cutters.

Facile à installer

A really good way of horizontally stacking PIs. Works with Pi4 also.Was a little tight on my DIN rail so had to slide on from the end, could just be my rail.

Ottimo per i serire il Raspberry sul quadro

値段が高すぎる。あと、カバーもあれば素晴らしい製品に仕上がると思います。

Great but expensive