Universal 2.5M Car Front Bumper Lip Splitter Spoiler Rubber Skirt Protector Body Trim 8.2ft (Black Protector)

Looks pretty good so far on my 2025 Toyota Prius. We’ll see how it holds up after scraping my driveway a few times. NOTE: If you are going adhesive only with no screws, follow this advice: clean the bumper thoroughly with isopropyl alcohol until it’s spotless, wipe with a 3M adhesion promoter sponge, use a heat gun or a hairdryer to heat the adhesive tape as you stick it on. It will stay put if you do this, I promise. I’ve had no issues with speeds at 80mph+ and after it’s been in the snow and rain. It’s rock solid.

Just added this after my expensive lip was torn off by an entrance to an unfamiliar gas station. Really easy instal. We’ll see how long it lasts. I bought 1/4” by 1 1/4” stainless steel washers for the screws to hold it better. About the size of quarters.

I know other reviews say it tears easily and the adhesive is not too strong. Both are true, but if you are careful with handling it, and properly clean the surface, it should be a solid install. Once I received mine I added my own Scotch outdoor mounting tape on top of the provided tape after removing the film. Then mounted it onto my front lip. The front lip I have doesn't have a full surface below so I was due to add more mounting tape to keep it in place. It gives the lip a larger look and will it protect? I doubt it but I like that it acts as an additional guard. Thanks for reading!

I normally don't believe on adhesion products for the exterior of a car because it's outside in the elements and sure enough the front started to peel back. I did have to cut mine because of my bumper shape, so maybe it would have stayed if I had a solid bumper but it also dropped elsewhere on the rounded sides. But overall I like it, the lip looks good, it protects bumper but I ended up adding some screws to keep it from coming off.

This “ air dam” stayed attached for years after factory air dam broke and fell off of my Chrysler van. Good product. I am just now writing this review 3-4 years late. Lol

I have gotten these rubber lips in the past from other brands, this one is exactly the same as a good quality rubber without bubbles, but big bonus points is that it comes with 3M tape and some screws to make sure the lip is not going anywhere, at a very reasonable price. Highly recommend it.

This is great for protection and looks but very weak against wind and water. Installed it on the 17th or 18th of April and it has already started to remove itself. I cleaned the area, installed it properly, and put pressure on it to make sure it wouldn’t fall but none of that helped. I don’t think I can get a return or replacement so to Home Depot I go. Sadly I will need to buy screws and screw it in to my bumper. If you really want the protection and/or looks but don’t want to pay a lot for a splitter or real lip, prepare yourself to buy screws and screw it into your bumper thus defeating the whole point of protecting your bumper.

Wanted something to just add a little " something " on to my paint matched front lip that wasn't too obnoxius and cheap this came out perfect cost $20 and used some self taping screws as I don't think double sided tape will ever be strong enough for such job