B016KDNVNI

Update: Everything is quite well after about a year and a half of use with the shower panel and it still looks brand new! I did replace the mixer valve only because I wanted a true thermostatic mixer valve. I used the Rozin Solid Brass 1/2" Thermostatic Mixer Valve for Shower System Water Temperature Control Chrome Finish, from amazon.com. It matches the other valves, was an easy replacement, and is a definite improvement. I installed this in my motorhome right after it was delivered, this is one box that wasn't going to gather any dust.. Installation: - I removed my old RV fixtures and used EternaBond RSW-4-50 RoofSeal Sealant Tape to seal the screws and large holes for plumbing access. - I held the fixture up to see where to mount it, unfortunately the existing plumbing access holes determine where this has to go so it is a little off center and that will have to be fixed at a later date. I think getting an appropriately cut piece of polished aluminum or preferably stainless steel to cover the area will allow me to move the shower fixture into a better location. Another expected problem was the height of the fixture, to resolve this I cut the frame around my skylight that is over the shower to allow the new fixture to go up another 1 1/2 inches; and wallah another problem resolved. Again I used the sealant tape to close up the cuts I made. - I marked the locations to install the top mount and then measured down 37 3/8" and installed the lower mount. - I changed the batteries to a quality AA battery and put the battery pack in the pocket that seemed to be an obvious place for it to go. - I installed the handheld shower flow through holder with another screenless washer and my favorite handheld shower unit because the one that comes with the unit looks like a cheap piece of plastic junk. - Time to do some plumbing, fortunately the RV uses standard 1/2 inch FIP faucet connectors so it made the installation very easy. -- I installed two new screenless washers in the RV side and then tightened on the two 1/2" x 1/2" elbows that were included in the installation kit. I used screenless washers because I have filtered water and I also have an on-demand water heater that requires full water flow to work properly. -- I then put two more screenless washers in the fixture hoses and tighten them down to the elbows. -- Make sure you don't kink the hoses in the fixture or you will have problems, by the way they are very easy to kink. - Now I simply hung the unit up and admired it for a minute. Time to get naked and get in the shower (sorry for that mental picture, LOL). I got in got the temp adjusted right and tried the various features and they all worked very nicely. The only thing I didn't really care for were the two large round fixtures that really weren't very powerful. Everything else was great. The LED lights weren't working, oops remember that switch on the battery pack! I reached around and pulled the battery pack out and turned it on and presto I had LED lights which were kind of kool. As a side note, set your temp where you like it and leave it alone, use the feature valves to turn the water off and on and you will always have the perfectly adjusted shower, at least until your significant other changes it. I did get the shower panel at a much reduced price because I bought a slightly damaged unit, but it doesn't affect anything and I readily took care of the minor damage. I cannot say enough about how great this shower panel is both in appearance and functionality, not to mention how easy it was to install. It was really very convenient that everything was included in the installation kit for a standard install. The only features that could use improvement is the handheld shower and those big rings, but then maybe somebody else likes them. I'm going to buy another one for my parent's home.

I love it! It is a great bang for your buck. You get the bells and whistles without spending all of your money! We had the plumber put it in. It seemed pretty easy to set up.

I wanted to upgrade our standard shower head and hot/cold control with a shower panel after visiting a hotel with a shower similar to this. First off, after it's complete... it is amazing!!! It is hard to comment on a universal install because everyone has a different situation. It wasn't exactly easy to install, but it wasn't hard. From the photo, you can see we have a tile shower. I had to cut off the old hot/cold regulator (in the small tiled opening!) be careful not to lose the pipe in the wall, that was a challenge to get back. Then I got some shark bite fittings from a local hardware store and extended the pex pipe to come out of the wall a little bit since there is plenty of storage space in the panel itself. Sadly, this was the easy part! Next, I had to figure out how to mount the panel. It isn't heavy, maybe 15lbs.. so I first thought of trying to use the 4 mounts glued with double sided adhesive. It held for about 4 hours then fell down.. not a good idea. So I decided I ultimately have to drill holes in the tile, which is a daunting task. I'm no pro - so after about 2 hours, I had 2 holes drilled! I'm sure there was something I did wrong, I had used a diamond tipped carbide bit but apparently that's still not the key to getting it done quicker. Long story short, I got 2 holes done and that was enough... I screwed 2 mounts into the wall at the top and used double sided adhesive for the bottom ones to keep it from moving. It has been up for about a week and no issues at all! I found that our plumber originally placed flow restrictions so that explained why our old shower head had such low pressure. Once I installed this unit, the pressure is great and we can easily run 2 options at once. I imagine that you need a large water heater to take a decent shower if you opt out of any restrictions. We have a 75 gallon gas heater and havent had issues. When it is all said and done, it is amazing and elegant! I'm very happy with the purchase!

I can't say enough good about this fixture! We absolutely love it! We love the different modes including rainfall, waterfall, wand and car wash! Despit what some say, you are able to have waterfall and car wash on at the same time. It largely depends on your water pressure. The only reason for 4 stars is the directions are complete dog poo. They are for an older model so you'll have to kind of figured out how to assemble this model on your own. Even the QR code links to a video tutorial of the old model. It isn't that bad, mostly annoying. I'm pretty dumb and I figured it out. Love the final results!

Updated 02/27/2022 less than 5 days of it being in operation the temp/timer display went blank. But the leds on the display are working as are the LED's up top. You can send an email to a gmail account and maybe they get to you, but they seem to be attempting to stretch out the support request so you are stuck with the shower. There are no parts available it seems, Amazon said as much. So at this point, I'd recommend you stay away from this company. ::Orig Review::: We replaced another shower panel that had parts falling off :) This one slid into the same spot without any drama, seems that most of them have a "standard" mounting span. This has great pressure, really good. Be honest though the flow reducers were pretty mangled, so not sure if they would have caused issues, but because of that, we removed them.......... (waits for knock on door).. Okay good. So good pressure, it's a bit of an issue that the top can't be extended or changed, so you are limited and it makes me feel like i'm closer to the shower wall (with the panel), vs in the center of my shower, a longer shower head would have been nice, one that was deeper and wider,. Wider, well this shower head is like 3.5" so it's fairly narrow, it works, but my wife felt that it made her feel that she was able to easily move outside of the range of the shower and when it's 58 degrees inside, it gets a bit chilly. So we believe the top shower area is too narrow, but pressure is awesome and features seems pretty good. Cheap plastic spray handle (crazy that they go this cheap on that, while everything else is metal.

First impression is very positive. I read all of the reviews and alway benefit from them so this is my way of paying it forward. For the most part the quality looks good although as other reviews have cited, than handheld shower is plastic and feels cheap but other than that it looks great and I just hope that it holds up for at least 3 years since replacing it would basically require me to redo my shower upgrade (more of the install next). The shower pressure is perfect, and I’m addition to the 2 massage jets, I like the other 4 pressure jets which basically give you a lot of functionality in one package which is to the benefit of a shower pane vs. a customized shower. As for the install, as others have mentioned the unique set up with the two hoses require you to redo your existing plumbing so my contractor suggested installing the pictured access panel in case I need to remove the shower panel or theoretically minimize the need to change all of the tile if in the future I decide to go back to a normal shower. When installing be mindful of the height as I had initially installed it to high (trying to clear the shower door so it could open inwards) but the top massage jet was at my face level so I had to lower it. Other features, the led lights seem gimmicky and it would be great if they had other colors since it’s only the blue pictured but I was glad that the lights and water thermostat are battery powered. But all in all I’m very happy with the shower and features so as long as I don’t have any future problems with it and the paint holds up without chipping away for 3-5 years I’ll consider this well worth the price.

I had half dozen bathroom done in the past & got couple much more expensive shower panels. But this one is in another level!! The jets are so powerful and the temperature display exactly what I want ever time. I'm taking 20 min showers and usually 3X or more a day. Thank god my water bill is paying by the HOA. If you are a golfer or like sports, this shower panel is a must have, I mean it actually massage your & hard to reach spots since the jets are so powerful. I like so much and installed a 2nd one in the guest bathroom. I know is kind of hard to figure things out since it has so many option but rule of thumb is just once turn to the jets you like, then start playing with the other dial to make it stronger or weaker. On the 1st installed, I made mistake & try to covered the old shower hole, it was kind of too high, make sure the top most jet will not shot to your smallest person's face in your house. For the price that I was paid for these couple panels, just 5 less massage sessions you'll get it back. This shower panel should be giving 10 stars on a 5 starts rating system.

We absolutely loved this shower for about the first 10 months or so and then it started leaking consistently due to one of the valves that was faulty. This resulted in a constant drip in our shower which also made the floor slippery and a little dangerous. Additionally, the hot water cartridge started malfunctioning. When we would then the shower panel on, the motor wouldn’t run and the water wouldn’t really heat up. Then we’d hear it start and stop as if it was trying to get going. The lights would even start flickering in the bathroom. After a few false starts over 10-15 minutes, it would finally turn on and the water would turn from luke warm to scalding hot in a matter of seconds. Took several emails to Ello and Allo over a matter of two weeks to communicate the issue and get them to mail me another valve and hot water mixing cartridge. The package came with just that- no instructions or manual to assist with replacing and repairing the panel. I’m typing this as our plumber struggles to figure out how to fix it... apparently the pressure pump is now not kicking in when it’s turned on. Looks like we will be exchanging more emails to try to get this fixed.

We have had this unit installed more than 2 months ago. We use it consistently. I guess, that for the price, we were expecting a unit which was better built. We find that the following things are annoying. (1) The temperature control is very sensitive. A little bit of a turn makes a very big difference in temperature. (2) The control knob labels are impossible to read when you are using the shower unit. They are even difficult to read with the shower off. (3) The thermometer is in Fahrenheit. We use Celsius in Canada. I can't contact anyone who can help me with that. (4) The handheld wand is plastic. Ours already has a mark on it which will not come off. It is very flimsy. The control switch is very difficult to move. (5) The manual is very minimal and difficult to read. (6) Worst of all.... I have had zero success in contacting anyone who I can deal with regarding any problems.