High Strength Utility Pulley Block by WinchBrothers (1)

I like this pulley. It handles some tough work.

They work fine for hoisting deer and hogs with a boat trailer winch.

Good heavy duty pulley for what I use it for. I purchased this to act as a snatch block for my ATV winch when utilizing the plow for snow. I have had pulleys on the plow before and they have always worked for a little bit and end up falling apart. This so far has held together for the use on the plow and gives me a greater range of motion with the plow and the winch moving it up and down. I bolted this to the push bars of the plow frame and ran the winch cable back up to the front cross bar of the ATV frame. It hold extremely well and I have used it once so far this season with no problems at all. I would highly recommend it to those who use their ATV for multiple uses with their winch.

After a free months on a stainlessness steel cable the wheel busted on the block, wouldn't buy again.

Great product

This pulley is supposed to work for 4000-pound loads. I bought three and put them on my Bayliner boat hoist which is in freshwater; less than 2 months later one of the pullies was no longer spinning. My boat weighs 2500 pounds. I took one apart today and the bushing was almost completely worn out. I bet my hoist only went up and down 10 times and the pulley was shot. Do not buy the pullies unless you have a very light load. I would request a refund but think it has been too long. I am very disappointed.

VERY stout and rugged. Just what I need to double the cable on my come-a-long so that I can pull my anti-roll torsion bar on my 1987 Chrysler 5th Ave into place and replace the bolt and bushing that is missing.

This has no bearings, bushing or any other means of reducing friction. It's a steel wheel turning on a steel bolt, and it froze under load.