Auto Wayfeng WF® HD Car Runk Handle Parking Rearview Backup camera Case For Audi / VW / Volkswagen / Passat /Tiguan /Golf /Touran /Jetta /Sharan /Touareg 2011-2016

I got good results installing this camera with an auto dimming mirror that has a built in monitor. The camera has a RCA output and the mirror has a RCA input. The new camera has a trunk switch which releases the trunk lock. Viewing angle is correct.The wiring instructions that came with the camera do not work on a VW car. The instructions say to connect the camera power to the car reverse lights. VW reverse lights do not put out 12 volts, so the camera does not work or there is a lot of interference. Voltage regulators and noise filters did nothing to help.I got the camera to work properly by using an automotive relay, the little black cube with 5 terminal connections on the bottom. The reverse light voltage is strong enough to trigger the relay, so I connected the + to terminal 85 and a ground to terminal 84. I ran a new line directly from the fuse box to the trunk and connected to terminal 30. The the out put from terminal 87 is connected to the camera +. I connected the same negative from terminal 84 directly to the cameras negative. The results are that when I put the car in reverse it triggers the relay, and I get the correct voltage to the camera. See attach picture for results.Be warned that this is a big job: added a fusible link to the fuse box; connected the red wire on the RCA cable to the fusBle link; ran the RCA cable from the fuse box, to the trunk under the door sills on drivers side; pulled back the liner in the trunk to locate the reverse+ (it was a light blue wire in my case); installed the automotive relay where I tapped into the reverse wire; removed the plastic cover on the rear lid arm to get the wires into the lid, removed the rectangular panel on the inside of the rear lid (there are two screws and eight clips holding it in place); then you can access the backside of the old trunk switch. There are two 10mm nuts holding the old trunk switch.This camera should work with any monitor or radio with a RCA input. However the old RNS315 & RNS510 headunits use a RGB 26 pin input, so I don't know if there are any reliable adapters.

Perfect fit for my 2013 Volkswagen Jetta SE 2.5. Install was easy enough without instructions. Comes with more than enough cable to run from back to front. The camera has the guidelines but doesn’t have the static lines that shows were your car is going to be but you can’t expect the world for that great of a price point. Just has the lines for knowing how far to back up (green, yellow, red). The button to open the trunk lid works perfectly as well. Quality is very comparable to the original. *Note: noticed the original handle has a slot for a camera when I took it off so if you wanted to just take the camera and rubber cover to use with the original I think it could easily be done. Just installed so if any iasue arises I will update.

Todavía no la conecte

It fits perfect with my 2013 VW Jetta however you cant adjust the angle of the camera which points darn near to the ground. Wish I can point the camera up just a tad bit!

I like it because it is more concealed look than a license plate camera. It is more discreet look. Just glad there was one for my Jetta. Delivery of product I thought was fast.

I installed the item on my car but it didn’t function at all, no display no image. The size isn’t so perfect for vw tiguan 2012 either. It fits and can be installed but doesn’t fit well in place.

Super skeptical about buying this camera for my vw jetta 2013. Once i had it installed, i was surprised on how the quality exceeded my expectation especially on how cheap it is. Highly recommended buy.

Lo instale en una Q5 y funciona al 100%