BCZAMD PT1000-550BW Temperature Sensor Probe for CR-10 Plating Copper/3D Volcan/ V6 Brass 3D Printer Heater Block Thermistor Sensor Probe Resistant to high Temperature 1.5M/ 59 inch

This device seems to be what it says it is at a very reasonable price. It worked well with the Bigtreetech EBB36 CAN with built in MAX31865 chip. Temp readings seem consistent with other PT1000s in the same environment.

Haven't put this to use yet, but quick resistance check at room temp checked out and matched PT1000.

Despite some other review(s) this thermocouple is a PT1000. I tested it down as close as I could to 0c and it ohms close to 1000 ohms which make it a PT1000 platinum based thermocouple.

everything works as it should. however, the ender 3 v2 cables are 1.2 m long. this is common knowledge. I don't understand why everybody provides one meter cables that have to be extended which is what I have to do. please update your product to 1.2 or 1.5 m so that it can be used on more printers.i wound up taking some of the old wiring from the old thermistor and extending this by about 8 inches. i used JST connectors on each end of my extension and this thermistor cable so it is a plug and play extension. i then heat shrinked over the connection so they don't come unplugged and importantly re-hotglued the plug into the motherboard.for klipper, sensor_type is PT1000 per documentation.

These are definitely pt1000. The leads are nice and long, using with a duet 3 toolboard. Tested with a thermocouple and reading is spot on at 24c and at 250c. Very happy with them.

manta m5p has a jumper you use with pt1000.. this thermistor reads around 130 c with jumper ... remove jumper and it drops to a reasonable temp.. buy with caution

Installed and brought up to 250c and did a one-hour test print without any issues.

Installed this sensor after a different brand of PT1000 broke on me. So far I have only done a single ABS print at 250°C, so I haven't yet tested its resilience to more extreme temperatures.