Eagle Tool US ESP50036 Installer Drill Bit, Screw Point, 1/2-Inch by 36-Inch, 3/16-Inch Shank,Made in The USA

Worked for what I needed it for, good sharp drill bit. The rod itself is not that flexible but I just needed it to drill down through the bottom of a stud wall through an opening for an electrical socket to feed the cable through, twice, and it worked perfect. Never know when I might need it again, or friends/family to borrow.

I tested this on my test rig and it works as expected. The flex of the rod is not bad.

Worked well, not as flexible as I thought but done the job and it's decent quality.

Worked perfectly for drilling down through a horizontal stud to run cables from a light switch

Its handy to have in my tool box but its not as flexible as i thought it would be. In fact its not flexible at all.

5star

Doesn’t flex

Good quality, made running cables through floor board a breeze

I've used this drill bit to do a "new work" electrical outbox for coax cable and outlet and to drill joists for the same cable. I drilled around 15 holes in total.Overall, I'm pleased with the quality and drilling speed of the product. The drill bit wasn't as flexible as I expected but this is my first one so I guess my expectations were a bit off. I found it extremely useful to drill joists if you have a hard time to fit your drill with a standard drill bit or you have different objects (e.g. air duct, electrical wires) in a way.

We use those everyday in houses to get new wires in wall, very good product, it is also not expensive for this kind of tool!We resharpen them once or twice before they are dead. If you never hit nails they will last very long but the reality is that you will get nails or worse a screw. I did contact their support for 2 questions before re-buying and they told me some nice answer that I would like to share here:What is the real difference between the Auger and the ScrewPoint? We usually drill going up in 1.5 to 3in of wood.We also sadly hits nails from time to time so do one perform better if you happened to hit a nail? We usually hit it then try again somewhere else.The ESP was the first design for a cable bit by the inventor many years ago. Most people are more familiar with an auger style bit and this is where the EA came from.ESP cuts a bit faster and the EA leaves a cleaner hole. That is the only difference I see.Nails are a problem, all of the cable bits are manufactured using 4340 and heat treated to 53 to 58 Rockwell. We do not make them any harder because they are mounted on long spring steel shanks and the torque involved in cutting through steel can cause the shank to snap and could cause serious injury. We would rather you sharpen the bit than be injured.hope this help! 10/10

Saved the day. Split level I needed to get under the floor from about 5' from the laundry room (no ceiling). Drilled through two 2×12 joists and through the floor from the upstairs cable outlet hole, and using a cheap endoscope I got here on Amazon managed to pull a string and then a Cat6 ethernet cable.Only downside was having to cut the cable clip protector off as the hole was too small for a molded ethernet connector. If you are running ethernet, I would recommend the next larger 3/4 size.They recommend a two handle drill, I used a regular drill. Hold it tight and use a medium high speed. Too slow and it gets stuck. It is rather stiff, didn't bend to follow the wall as the video showed, but an angled hole works as well.

First of all let me comment on the fast delivery- I ordered it on Wednesday and it arrived on Friday! I’ve already used the bit and it worked perfect- quality product Made in the USA! I will be ordering again!