Charnwood DC50 Woodworking Dust Extractor 50 Litre, 0.5 Micron Filter, 2m Hose

My god this thing has got some suck to it, that much that if you put your hand over the extract pipe it jolts the drum and falls over (obviously your not ment to do this) I have some big expensive extractors in my factory and this little beast really does show them up. Highly recommend this for any workshop with fine dust to planner chipping

Good product. However if using reducers and multiple hoses for different tools. It isn’t very effective. Gets really hot and it’s not designed to pull air as fast in my opinion. I use it to remove dust from a child in the top of the workshop. However using for power tools is problematic ✌️

What can I say, I am 71 and had to wait till I could afford a workshop dust/chip extractor, cost £119. What did I get for my money, A PIECE OF JUNK, after just 2 minuets turned on the motor end got sot hot you could not touch it, the 100mm pipe is connected to a charnwood Y piece then to a 75mm pipe. After using my router I tried to suck up wood chips and dust, in the end I had to use my 12 year old VAX hoover to do the job. If you need a chip/dust extractor DO NOT WASTE YOUR MONEY ON THIS MAKE, Look else where, COULD NOT GIVE IT no STARS SO IT GOT 1. A very pissed off pensioner

Used for my piped dust collection system and does the job with plenty of suction for my small shop; pretty noisy in a small space, but with a bit of sound reducing enclosure it's fine.