Rain Bird25PJDAC Brass Impact Sprinkler, Adjustable 20° - 360° Pattern, 20' - 41' Spray Distance

I had tried another product (German manufacture) which looked the part but fell to pieces after a few days and decided to try the original Rain Bird. Quite superb and easy to set up / control (unlike the previous which had no instruction whatsoever) The Rain Bird looks built to last and I have ordered a repeat. It took 3 days to get here and in any case cheaper than the rather poor copy from elsewhere!

I bought this to upgrade an olastic one and it is way better both in terms of sturdiness and functionality. Nota that is a 3/8" thread not a 1/2" thread. The larger one is a 1" thread not a 3/8" thread as stated. I had to end the large one back and replace with this to get the 3/8" thread I needed.

Tricky to get set up, but once done, perfect

I have bought many similar sprinklers and every single one doesn’t work properly, they never change direction as they should or they break after a short time but not the rain bird, this is the best around and I cannot recommend it enough wish I had bought this one first

The original and best. Bought this as we had a heatwave in the UK this summer. I have tried cheaper imitations... they are not a patch on this. The build quality is superb and you can immediately tell the difference in the greater control over the spray length and pattern. Buy it you won't be disappointed!!

This is my favourite type of sprinkler. I have had quite a few different types of device in the quest to keep my lawn looking reasonable in the Summer but this is the best. This type of sprinkler is available in plastic for about a third of the price but they don't last so long. This one is real quality and I am sure that it will give many years of service to me.

I always promised myself that one day I would stop buying cheap versions of impact sprinklers and go for Rain Bird Brass and I am delighted that I have made the move as the results of growing vegetables is enormous.

The media could not be loaded. Not sure what water pressure this thing requires but obviously mine is not enough.When it's screwed into the 1/2" base, the threaded section allows the body of the sprinkler to rotate inside it, this tolerance is also up and down as well as around.This causes the head to drop when the water is off and when the water is put back on, the pressure is not enough to raise it up again, meaning I need to flick it up manually. ( My video shows this better)When the sprinkler head is in the raised position it starts to rotate, but when it reaches the limit stop, it just sits there. It does not traverse back to the other limit stop to then repeat the sweep which is how this sprinkler type is supposed to operate.I'm not sure if it requires a higher water pressure as the chart on the instructions gives a starting PSI of 25 which is probably more than most UK households. Either way it did not work for me so it's going back.Really disappointed as I had high hopes for this sprinkler head.