ART CLEANBox Pro Dual Channel Level Converter

Great converter, works perfectly. I'm using it for subs that I'm running through a couple of Crown XLS-1000s (1,100 watts at 4 ohms in bridged mono, baby). I haven't noticed any noise (hard to hear with subs, but even so), and the controls are simple and easy to understand. Being able to adjust the line level to match my other gear while leaving the gain alone on the amps has been great. It's built like a tank (this thing would survive on the road with real pro gear, I'm confident). It is a reasonable value for something made this nicely and looks pretty decent. It certainly doesn't have the aesthetic appeal of vintage brushed aluminum gear, but it's not the ugliest thing I've seen in a stereo setup. Overall, I hope I don't have to buy another one, but I'm glad I got this one.

I was dealing with a frustrating audio issue where my signal levels didn’t match and I was getting unwanted noise and distortion when connecting my equipment. No amount of gain adjustment fixed it—the signal was either too weak or noisy. The ART CLEANBox Pro completely solved the problem. As soon as I installed it, the signal was clean, properly leveled, and free of hum and distortion. The dual-channel design is perfect for stereo setups, and the level controls make it easy to dial everything in exactly where it needs to be. This unit does exactly what it’s supposed to do: converts signal levels cleanly and reliably. Solid build, simple setup, and immediate results. If you’re struggling with mismatched audio levels or noise in your system, this is the fix. Highly recommended.

perfect conversion from balanced to unbalanced signals, and back. Liked it so much I ordered another one!

I'm using to connect a CD player(RCA) to a mixer(XLR). Seems to work ok, but even with my mixer preamps both set to 0, I had to keep the levels for the left side at 5-10% and the right at about 50% to have consistent levels. For what it is, I feel it should be a little less expensive, and the design is a bit dated, but it seems to work well and that's what's most important.

A device intended to increase the voltage of a pre-out from your receiver. I can't think of a better use for this than to hook up a Pro AMP with a consumer HT Receiver for subwoofer use. Why? That Pro AMP will want a higher level of voltage before it will decide to do anything with it and your HT Receiver doesn't provide a good amount of voltage on the LFE Pre-Outs without running it super hot. Why don't you want to run the pre-outs at max? Well a few things can happen; 1 - can cause artifacts in the signal which can affect the sound, 2 - lower the lifespan of the pre-out and 3 - not be enough to drive the external AMP to max power. (#3 is the most important) Why use a Pro AMP? Cheap power for great performance AND most give you DSP (Hooray!). Now, consider this, DSP (Digital Signal Processing) IS important and these don't provide that but there are products that will provide signal boost and DSP capabilities. They are more expensive but at the same time a better solution than going Boosted Signal -> AMP w/DSP. For an introductory to setting up your HT, going with a CLEANBox Pro -> Pro AMP w/DSP is probably safer, easier and cheaper, maybe just not the best approach. Been using mine for almost 2 years now, honestly I forgot I had it till the other day when I had to move it. My major qualm is the form factor, I know car use was a consideration so smaller sizes are important but for HT use the size is somewhat a pain on initial set up. After that though its fine, still wish I could get it in a bigger box style. The uses for the CLEANBoxPro has been restated many times, figured I'd put in mine! Would I buy again? no, but that's not against the product itself, I just want something with DSP so I can put a bunch of power amps after it.

My current setup is a Project Debut Carbon DC turntable into a Music Hall PA2.2 into the Art Cleanbox Pro into a pair of JBL LSR308 monitors. Before the addition of the Cleanbox pro i just wasn't able to get the volume i wanted out of my turntable, i felt like i was getting about 50% of what the should be capable of. After doing some research about consumer and pro audio levels i bought this to bump up the signal and i must say it does an outstanding job. I was worried that this might degrade the sound quality of my turntable buy i can't hear any negative affects. This increased the volume of my speakers by at least 30%-40% which is exactly what i was hoping for. As a bonus you can control the volume of each monitor from a central location which was a big plus (but not needed now because my phono amp has a better volume control knob) I highly recommend this product for this type of setup.

Excellent product. Great value for balanced to unbalanced audio connects.

I needed this unit to resolve an issue with a long cable run of around 30 feet that was picking up hum and interference along the way: I was feeding the left and right channels audio output of an OPPO 205 blu-ray player to the inputs of a Marantz preamp. Unfortunately, the Marantz tube-based preamp does not have balanced inputs, only unbalanced RCA level inputs, so I couldn't take advantage of the OPPO's balanced outputs. And unfortunately, I had to place the Marantz far from the OPPO. Using the unbalanced outputs of the OPPO and the long cable run resulted in picking up significant hum from other cables running parallel to the unbalanced RCA cable between the OPPO and the Marantz. One obvious solution was to place both components in close proximity to avoid the long cable run altogether, but unfortunately that is not possible. The ART CLEANBoxPro solved the problem completely: I ran a pair of shielded mic cables from the balanced outputs on the OPPO player into the ART CLEANBoxPro positioned right at the Marantz preamp then used the unbalanced output on the ART to feed into the Marantz's unbalanced RCA inputs - it completely cleared up the hum and interference issues. Problem solved. However, be aware that the ART inserts a significant thump when powered on so you may want to turn it on first before any power amps are turned on to avoid the thump, and reverse the turn off procedure when turning the equipment off. Other than that issue, the ART is an excellent tool to solve a particular problem.

It did exactly what the literature said it would do

Muito bom. Superou minhas expectativas. A embalagem veio meio deformada mas o produto estava intacto.

... aber was ist es überhaupt? Was könnte das Gerät noch? Ich hatte ein Gerät gesucht, mit dem ich Sound (vom Rechner) auf meinen digitalen Recorder aufnehmen kann. Unbalanced > Balanced. Die einschlägigen Websites empfinde ich als unseriös. Das Aufnehmen funktioniert prima - ich bin sehr zufrieden! Keine Nebengeräusche oder Brummen. Aber ansonsten ... muss ich mich in die weiteren Fähigkeiten leider noch einarbeiten.

Great, glad I purchased. Woke up my sub/amp

This is the second one that I own and they work really well!