13Pcs Preset Torque Screwdriver with S2 Bits, 1/4” Drive Torque Wrench Screwdriver Set for Maintenance, Tools, Bike Repairing and Mounting, Inch Pound Torque Range 10-70 In-lb

Although this Coobeast torque screw driver has a limited number of driver attachment (12 to be exact) compared to some other kits of higher cost, this torque screw driver is quite adequate for my purposes in limited gun smithing (mainly RDS sight mounting and basic maintenance etc). Luckily, the drivers included happen to be the ones I actually needed. Of course, YMMV and you may have to purchase 1/4” bits to meet your specific needs as only 12 bits are included in this kit. The torque settings are easily set between 10-70 inch/lbs (most torque specs in my use case run around 15-20 inch/lbs) and the driver bits fit into a shaft length that is well suited to my purposes. The diameter of the screw driver handle is large enough to make it very easy to apply the selected torque but not so large as to get in your way (unlike some right angle type torsion bar torque drivers). Everything comes held in place in a nice compact case that helps to keep everything organized and fits well in my smithing/maintenance bag. As far as accuracy is concerned, I have yet to test this driver against my electronic torque meter so TBH I cannot comment on this, but so far I have not run into any problems with my sights or mounting plates coming loose nor the screw threads stripping so I assume that it is “good enough”. Again, for the price (especially the limited time discounted price) this is an excellent value that has earned a permanent place in my gun smithing kit.

Perfect for gunsmiths, electronics, and ski techs, any job where over tightening can lead to stripping of expensive thread holes. Good selection of bits, except it could you some JIS (PH#) bits for ski binding work. Easy to read and adjust torque values. I recommend backing off the torque to zero each time for storage and before use. The tool gives a good click once you achieve the pre set torque.

Doesn't have any T star bits. Works excellently just wish it had more of what you need and less of what you don't.

This is allround good for scope and optic screws, a must for a fire arms sportsman!

Been using this for a while now, have to say it's nice to have on hand especially for smaller screws that need to be torqued the same. Can't speak to it's accuracy but that would be with any of these regardless of brand unless you have a certified test unit.

Perfect! This torque screwdriver is very solid and for the money you cant beat the quality. This feels like a very expensive torque screwdriver but at a budget friendly cost. I bought this for my small gunsmithing projects and I couldn't ask for a better tool. Highly recommend this product. If you are considering this item go for it, you can thank me later lol.

Excellent torque screwdriver to torque screws quickly. I use it to install switches and outlets. requires about 14 in. lbs.the bits they give you are good, but I use my own. I use Milwaukee ECX #1 0r ECX #2 Bits. Aso available on amazon. They are made for electrical screws. they don't slip out of the screw. If you are doing electrical work always turn the power off and test it. also check torque requirements.

Awesome product for the price just what I was looking for