Outdoor Waterproof Electrical Box Junction Box Weatherproof IP67 ABS Plastic Enclosure Switch Router Project Box Electronics DIY Enclosure With Mounting Plate Wall Bracket Grey 8.6"x6.6"x4.3"

I am wiring up ethernet throughout the house to maximize speeds. I did not want to place electronics in the hot attic, so I purchased the 8.8 x 6.6 box to hold a small ethernet router for placement high on the wall in the hallway. Both ethernet and AC power wiring enters through the ceiling and into the top of the box. The box makes all this look more professional and also provides for easier access in case I need to check on the router. Mounting the router inside the box was awkward because the holes in the board in the back of the box did not align, so I opted for 3m double stick tape instead. Adding holes to the box was easy using one of those costly conical tapered reamer drill bits which made short work on the plastic. The angled brackets to mount it to the wall are ok but it holds the box away from the wall a bit. Optionally I could have drilled through the back and mounted it directly. There was another bracket included which I could never figure out where or how it was supposed to be used. The box latches and seals tightly and securely, but that was not important for my indoor application.

Mounted a simple sprinkler control unit in it. It was just the right size, easy to mount on a brick exterior wall, and protects the electronics perfectly with a very strong seal. it's also quite nice looking, sturdy, and should last for many years.

Nice small enclosure with watertight seal on door. Has removable breadboard so you can work on your project out of the enclosure and when done, it installs with 2 screws. I added an N-type 3.0dBi antenna and a gland for the wire feed from the solar panel to power the 18650 battery charge manager and it's up and running! The quality of the enclosure is excellent with good hinges and appears to be stainless latching for the door. Drop a couple of gel desiccant packs for moisture just in case. I hid mine behind the solar panel to block the sun but the antenna stick out above it. Keep the heat off the electronics and battery. Comes with some mounting hardware as well. This is for the 5.9"x3.9"x2.8" enclosure listed.

Very nice product.Well built and strong with a good weather seal.Great valueHighly recommend

Like latches over screws to keep lid shutHolding up to weather very well 2 years plus

Really nice box for small electronic projects. Lots of mounting options and seals very well.

Very cost competitive. Well made for my application. Lots of space for electric components. I would not use outside.... I believe the pvc will become brittle and crack.

Nice product I used in a marine 12 volt application with 2 bus bars. Closes securely7 appears weather tight.