30mm Fan 5V

Works great. Easy to use. I made a dual fan cooling system for my Sony a5000 camera. This keeps it cool very well. No jitter and it is totally quiet. Highly recommend!

I purchased this fan on my third attempt to get a working 30mmx10mm fan for my Vilros Raspberry Pi 4 Model B starter kit case. The Vilros fan that came with the case was dead-on-arrival. The second fan that I ordered directly from Vilros directly was also dead-on-arrival. At that point I gave up Vilros fans and ordered this Easycargo fan. Fortunately this fan worked perfectly on the first try and was really quiet. In fact it cooled my system temperature down from 45C to about 33C in just a few minutes. You should be able to see that in the attached netdata image. I am very happy with the performance and quietness of this fan and highly recommend for this setup. And, although I cannot vouch for its lifespan because i have only been running for a short time, I can safely say that has run far longer than either Vilros fan. Also, this fan does not have the blue control wire to allow it to be toggled on and off but it runs so quietly, that is not an issue for me. I also want to say that, except for the fan, I am very satisfied with the Vilros Raspberry Pi 4 Model B starter kit and would recommend it.

When a Raspberry Pi eats another fan these are good replacements. Easy install. Quite and works. Perfect on price as well. You can't really have too many of these if you have a few Pis in use.

Seem like they do the trick. However they aren't as silent as I was hoping. Turn up the volume in this video and you can hear the sound when I stop the right fan. It's possible it's because how I had to mount it on this heatsink because these fans were too big. It works overall so I'm still happy with it, just wish it was quieter.

Great set of fans, but I do not have a raspberry pi... I have a Sony XDR-F1HD HD tuner. These have a known problem with overheating and not starting up the next time they're turned on. A fix is to install a fan blowing on the internal electronics. This little fan is an ideal fit - I "glued" it inside with double sticky tape and connected it to the 3.3V power supply inside the unit. This fan is very quiet and inaudible with the cover back on the tuner, and it starts up reliably now. I know this is a bit of a corner case use, but if you need a little fan that doesn't need much voltage and is super quiet, check these out! Oh, and if you're actually doing the same Sony mod I did, the service manual is available - just google it!

These are some nice fans. They are so quiet I had to put my hand over it to feel the air. The airflow is very nice for a small fan. I'm 100% satisfied. I can't hear my pi4 anymore that sits about three feet from me at my desk and it stays nice and cool. This beats the pants off the stock fan that came with my kit.

Seem to work well, quiet. Accidently put 16v on it to start, and it didn't burn up, so that's something. Tested two. Both reliably start up with as little as 2.2V. Almost completely silent at 5V, though being so small of a fan, you need a wet finger to even feel them running at that speed. At 6v, you can just hear it if you're a few inches from it, and at 8v it is humming pretty good. I think as another reviewer wrote, not sure how they came up with the 120ma amp draw at 5v; I didn't see anywhere near that. Closer to 27-30ma. Even at 12v and howling, it is only drawing around 55ma. I'll probably configure these to come on in a resistive load box at some preset voltage or just switched. Can't speak to longevity, but so far I'm happy.

Fit's my case perfectly. It runs quietly when placed horizontally or vertically. It makes a tiny scratching noise when tilted. My RPi v4 stables at 35.0'C ~36.0'C.

per il prezzo va più che bene, il cavetto è un pò corto e va bene solo se si vuole mettere la ventolina sulla scheda

Ottime ventolone 5v per il mitico raspberry pi 3, appena montata la ventola è silenziosa se mantenuta pulita e fa il suo dovere. La temperatura del rasp con ventola montata in media è 35° considerando che senza ventola è arrivato anche a 55 60° posso dire che funziona benissimo avendo la necessità di raffreddare un rasp h 24

Perfectos y silencioso

Sarebbe importante sapere a quanti giri girano le ventole cosi ci si fa una idea di quanto raffreddano, comunque è un buon prodotto e costruito bene.

Très bon produit. Silencieux à 3V, tandis qu'on entends peu de bruit à 5V. Avec ce ventilateur, en 3 V sur un raspberry pi4 et après 10' un sysbench sur 4 processeurs fait monter la temperature à 60 C, en 5V la temperature monte à 53 C dans la même période de temps. Je recommande.