Shackle kit 6426

They fit well, and had good install instructions if you need them. I was disappointed to find them not USA made though. These are a premium priced product. I personally could not install them (jackstands and a floor jack) without notching the bed supports. It might have been possible with a lift but not in my situation. I also added a 2.5 degree pinion shim for good measure.

Installed these on my 2018 F150. They were a perfect fit and it took me about 45 minutes to install. Got about a 1.75 in drop which definitely took away most of that obvious factory rake. I’ve read that some people needed to cut the bed rails to keep them from hitting but it fit great in my Ford. I have the crew cab with the short bed. All in all very pleased.

Solid lowering shackles . Worked great.

This leveled my 2020 f150 4x4 perfectly.This is a fairly difficult task, so be prepared.They explained everything plainly.

These dropped my truck 2”. 2019 f150 . Fit perfect.

After carefully speaking with people as to why these aren’t a good choice. Quality, not a problem very well built but. You are changing a lot of things in your suspension such as pinion angle, shock length and driveshaft angles. I did not install these so if you’re looking for some lmk

Works as advertised. Quality parts.

It says it won't fit on a 2021...but it does, nicely.

Shackles were easily installed in my garage by hanging the truck from a chain hoist and using an air jack to raise/lower the axle. I was able to do the job, with no previous experience, in just a few hours. Highly recommend belltech!

Well made shackles, lowered the rear end of my truck about 1.75 inches.

Awesome product, shipped fast. No issues with clearance or rubbing. Installed on a 2019 F150 Supercab 6.6' box. Did not need to do any cutting. Piece of advice for the DIY people, do one side at a time, have a friend help, remove the nuts on the factory shackles, remove the nuts on the U-bolts and pull the leaf spring to the side to get the top bolt out. You will need to remove the top bolt out of the driver side shock to pull the same side leaf spring over. Hope this saves some frustration for others.

Installed these on a 2016 F150 XLT Sport quad cab short bed 4x4.Not once have they made contact with the bed supports. I’ve even driven up on tall piles of snow to simulate a “Jeep trap” wash board effect. To max out articulation.... still no contact between the new longer shackle and the bed support.Great product. Easy to install. 2000km without issue.Note: do make sure to torque u-bolts and shackle hardware to OEM speck. Check at least once 100-200km down the road.