2 Inch Two Claw Puller Separate Lifting Device Pull Strengthen Bearing Auto Mechanic Hand Tools for Bearing Maintenance

Worked flawlessly!

I would not have been able to remove the bearings on my RM871 motor without this.However, the quality reflects the price, you get what you pay for.It did the job but it took some vise grips to hold the prongs under the bearings, but it worked.

Excellent and good price.

I would warn anyone not to purchase this item for several reasons: 1) The tip is soft and becomes deformed. 2) The claws slip and bend rather Han holding. 3) The Yip will walk because of the design and will not stay on the end of the shaft or nut. 4) The Item has a propensity to break under the most basic task. I would have returned it but I am outside my time limit. Do. not purchase this item. Spend a little more and purchase a quality puller.

Too small

It was well made and have several options to reverse the arms. It fitted well onto the race and the assembly stayed together as I remove the bearing.The bearing on my Sears table saw was gone and I tried every tool I have in my tool boxes. I always wanted to buy a bearing puller, but usually borrowed from Auto Zone or OReilly. They did not have one to fit this particular shaft and assembly, so I finally broke down and purchased this item. I saw several negative reviews and they "MAY" have been from improper use. You have to tap the head every time you tighten the screw. You JUST cannot keep turning the screw and expect the bearing to pop off.It may not work for some of my auto mechanic repairs, but 'Hey" Auto Zone is right around the corner.

Works as expected.

Not the best machining job, but worked well enough to pull a couple bearings.

well constructed. may be heavier for small unit work than needed but will certainly never fail

Me a gustado por que la gente en la mayoría de las reseñas Dan al producto de muy mala calidad yo me he ariesgado con prandolo si no lo colocas bien el extractor bien centrado es normal que al apretar se puede romper parami es fuerte,Yo lo he usado para lo que es para sacar un rodamiento de un motor estoy muy contento con el , precio de diez en ferreterías me pedían 70€ este no llega a 18€ a sin que vale la pena comprarlo la única pega es que va la rosca centrada un poco dura pero un poco de lubricante y ya está.

Very well-made product, very easy to use, delivered on time

two screws which are below are not solid enough

Great product, used it for removing a pinion gear from a e100 scooter motor. Damaged my first motor with a hammer trying to get it off, this puller removed it in 5 minutes without any damage to the motor. The puller tip did squash but it was a tough pinion. I will probably only use it once, but it was worth the money.