YEE PIN2019 Rogue Screen Cover Protector for 2017 2018 2019 Rogue Sport Connect 7Inch In-Dash Car Navigation Touch Screen Protection Film Touch Sensitivity

Easy to install and it really provides a slick but protected surface. I think the cover is even slicker than the regular glass. It is easy to apply and has no bubbles showing.

Works as advertised. Easy alignment. Good price. Bubbles are a bit difficult to remove, but eventually they came out.

Did not fit my screen on my 2018 Nissan. It was too long. Seller was very understanding and refunded my money. Great quality and packaging. Just double check your size before ordering.

Like all of these covers, it's a bit of a pain in the a$$ to get everything aligned 'just right' but this has been the easiest I've used yet. Had little bubbling and easy to push them out. Works well. Touchscreen still as reactive as before and finger prints less obvious. I would recommend.

item cracked near control knob before protective coating was even removed. instructions should have warned how fragile this piece really is. $15.00 down the drain. handle with extreme care. how could this be tempered glass?

this worked well!

Installed screen protector on my 2021 Nissan Sentra. Directions provided were fine BUT you have to be real careful when positioning it on the vehicle's screen. The suction cup provided is very helpful, but once you remove the film from the "sticky" side and start to line it up, be extra careful, as it "sticks" fast to the screen. It's a little awkward since you are sitting a little off center when sitting in the driver's seat, so you should also pay attention to how the top left edge lines up as you are using the suction cup to position the top right edge, per the directions. I may have "lucked out" and got it installed perfectly - the first time - but I can see how one could easily miss the mark.

I used this for my 2022 Nissan Frontier. The fit wasn’t perfect like my iPhone screen but it’s close enough for me. They give you two stickers that are supposed to hold the screen in place while you flip it up like a hinge and peel off the back. Then you drop it back down. These stickers are terrible though. My advice would be to use blue masking tap to reinforce the stickers and act like a hinge. Do a search for the video of a guy putting one on his Tesla. That will give you a better idea. Once the backing was off and I flipped it back down, it seemed to stick pretty well. There were a few air bubbles but I was able to smooth them out with my fingers. Overall I’m happy with it.