10AWG Adapter for 40V Ryobi Lithium-ion Battery Dock Power Connector Wire Robotics

Got two of these to use for a 36v ebike conversion. They worked very well. I connected the adapters in parallel and mounted them on the rear of my trike. It worked as planned and they seem very sturdy. .Little tight when I first used them but they loosened up after a few in and outs (work much better when they are mounted). I like the 10 gauge wire .. it was perfect for my needs and connected directly to the solar panel connectors i used. No complaints!

Used with both new, larger Ryobi batteries, and the smaller, older ones (2019 vs 2024). Older batteries are a snug fit, takes a firm pull to disengage. New ones are just right. Both are great, no worries about a poor fit or intermittent connection. My application is full of vibration and other stresses like dust, dirt, heat from the sun and so on, so 5 stars for that. 10 AWG tells me the makers have the right idea - you never know what people might actually do with your product, so better make sure that they can within reason. 3D printed, looks nice. Can't comment on durability until I break one, but looks like it will last. Well done and thanks!

The battery fit flawlessly the first time, the 10 gauge wires are not too stiff to work with. This was able to resurrect my wife's e-bike from a pile of components to a working bike again! It took longer to drill and tap the holes than it did to install and hook up the adapter!

I use these on my kids power wheels all the time. The kids love driving around the neighborhood pretty much everyday. Miles and miles. The problem is if you’re swapping batteries constantly the terminals will get all jacked up. Easy fix if I knew which terminals to swap out. I’ll report back with an edit once I figure it out and include the terminal number.

Straightforward, simple design, build quality is good.My OP4026 battery fits perfectly; confirmed output with a DMM.

I purchased this to create an easier way to power my trolling motor on my kayak. I ordered it along with a buck converter but that didn’t arrive so I had to get one later. It works great, I’ve converted the 40v to 13v for my 12v motor. I had it at 12v but the fish finder on the same circuit was giving me a low voltage beeps so I adjusted the potentiometer up a bit.If you have a project idea these adapters work great and they have sufficient wires on them to pull a lot of current. I’d recommend them to anyone who knows what they’re doing.

This is a fantastic accessory. I used this in combination with a 55v speed controller to convert a Yamaha powerwheels into a racing machine. The quality of the 3d printing on this adapter is fantastic. Nice and thick and fits like a glove.

I had an Milwaukee setup on my son power wheel and it work fine I switch to this setup with a ryobi battery and the power wheel started smoking soon as I connected it