Norcold 633292 Kit-Service Controls

Fixed the issue I was having with my old board. Great to have it running again.

I am a Full Time Rv'r not a pro and I followed instructions and our Norcold N821 refrigerator/Freezer is up and running better than ever! Had to use the short white wire as a jumper connection on the High & Low Limit pins.

Replacement kit was exceptionally easy to install. After installation I had the same problem as a few other people. Could not select the mode or change the temperature and it stated the door was open all the time. After searching the internet high and low I discovered a fix for this problem that was written by a Norcold technician. He stated that if you are sure you have the correct kit and have checked everything else you need to cut the purple wire behind the optic control board on the front of the refrigerator. Do not cut it too short in case this does not work you will be able to reconnect it. Once this wire was cut and taped off all of my problems went away. Now the kit works as designed. He said this process usually works on the older models, the serial number where this trick starts to work is not known. And it is not listed anywhere on any Norcold information.

Not exact to my fridge. Circuit board is the same but display is different and will not work. Disappointed that I spent unnecessary money.

This always seems to happen. Companies send a "direct" replacement. Unfortunately the direct replacement is for 20 different models. Of course it didn't work.

I installed this item but can't control temp or change mode there is what looks like a "d" on the display buttons do nothing

Everything went well. Good instructions! The only hard part was the space to work in installing the Control board.

Purchased this to replace a bad board and control panel for a Norcold Refrigerator. This does turn the unit on, but that is about it. I cannot adjust temperature, I cannot change modes, and the door closed code pops up because the door closed magnetic switch does not work. I contacted Amazon, they stated it was pass the return date but I could call Norcold. Then they gave me the number for "The Norcold Guy" and he stated that is not him. So I'm sitting waiting on the snails that work at Norcold to return under warranty. Seems I keep getting a lot of stuff from this site that works 50/50.

After a lot of trouble shooting my RV Norcold fridge I came to the conclusion that the circuit board or front fridge controller was faulty.Ordered this board and display as the reviews were very good. Installed quickly and the fridge fired right up and everything has been working perfectly ever since. Highly recommended this product.

Installed quickly, replacing the old faulty board.The only thing that wasn't obvious is that you have to jumper the temperature switch wire (see photo) in case you have an older model fridge without the switch.Other wires you just replace one by one from the old board to the new.The gas valve was marked GV and GV GND on my old board, while on the new one they are not marked, they are just 2 white wires with connectors that are attached to the main harness.Two days so far, fridge is working. Will update if anything changes

Easy installation

Fridge would ignite on LP but igniter would keep on clicking (spark) and after a minute the flame would shut off. I changed the sparkler wire because they said it also acts as the wire that sends the signal to the board telling it the flame is lit. When pulling the wire from the board I knoticed the lead from the capacitor pulled right out of the cap. So at that point I figured it was the board due to that.Ordered the new board, hooked it up and away it went without a hitch!

I used “the norcold guy” website to figure out which board I needed for my fridge.They wouldn’t ship to me in Canada so I purchased from this seller. Works great, easy install. No issues whatsoever.