34"W x 34"D x 36"H Down Draft Heavy Duty Canvas Cover for Evaporative Swamp Cooler (34 x 34 x 36)

Not only was it extremely good quality, but it fit perfectly. Highly recommended looks great.

Overall, this is a great cover. Taking it out of the package, I was hit with a blast of "Chemical" smell. This was probably from the waterproofing that was added b4 shipping. I recently took it down from its first winter in service and was pleasantly surprised to see that it had survived with flying colors. This was a perfect fit as I measured before ordering. A saggy cover will get tossed around in the wind and cause premature wear. The last cover I bought was a cheap "poly" material and lasted only one year. It fell apart in my hands trying to get it off the cooler.

I think this is a great product. Sturdy, sized well, and lasts for years. One suggestion for the product description would be to indicate that one of the vertical edges (top to bottom) is open/unsewn with velcro to finish closure when installing. This is a feature I wanted because my cooler installation has an electrical conduit along that edge, and an edge that opens allows me to enclose the cooler and leave the conduit exposed. I took a gamble when ordering, because the description didn't include that feature.

It fits. No complaints.

Purchased to cover two hanging 34x34x34 side draft swamp coolers. The covers are sturdy and the stitched seams are done very well with large/sturdy thread (I know because I partially deconstructed a seam - read below). The description said these are slightly bigger than the advertised size to make fitting easier and that was accurate. I expected to see seams on every corner but that was not the case which presented a challenge to me. The waterproof coating is a bit tacky (perhaps it is some type of paragon) and it comes off on your hands and clothes (see picture of my jeans) - after two washings it did come out and I discovered quickly to wear glovesBecause the coolers at our church are hanging I had to work around the support chains. I figured I would rip two seams and add snaps but only one corner was sown. I did rip that seam (very strong construction) and then added snaps to close it after fitting around the chain. On the other side there wasn’t a seam so I cut a 4” slit and added snap buttons on the end to help avoid any ripping. I did have to support one side of the swamp cooler so I could remove the chain and then quickly reinstall after fitting that corner. I did secure them with straps since it can get windy in the area where the coolers are located. The. Oilers are under cover so these covers won’t be in the direct sunlight which may have been an issue in the CO high altitude sun and weatherOverall very pleased with the construction and fitting but I question how well the weatherproof coating would hold up if exposed directly to the elements for a couple of years

Bought this heavy duty swamp cooler for a roof top mounted setup. Material is heavy duty, it fit snuggly. Thanks.

Heavy duty. Easy to install.

Cover old swamp coolers on roof prior to repair to roof.