2.2m / 7.22ft USB Gaming Mouse Cable Replacement for Razer Naga 2014 Line 14

After watching a few YouTube videos, I took apart my $100 Razer Naga left-handed mouse that had a broken cord. I carefully peeled off the slider stickers on the bottom and stuck them to the screwdriver case temporarily. After removing the screws and taking off the top of the mouse, I took off the screws holding down the main board. Don't lose the screws and don't mix them with the other screws. NOTE: You don't need to remove the mouse wheel from the board, as you may have seen on YouTube. Watch for one/two hidden screws on the right side by the ribbon. Using a magnetized screwdriver when reassembling will be incredibly helpful! Tip: When installing this new cable, route it under the board first but DO NOT plug it in until AFTER you screw down the board. Screwing down the board with the cable already plugged in was much too difficult. I was careful when removing the skid stickers so putting them back on worked fine. Otherwise, Amazon can sell you skid sticker material for under $10 that you can cut to size with an exacto knife, available here (https://www.amazon.com/dp/B01LZ44P6M). Good luck!

the cable of my naga (2014 model) frayed over time and it finally needed to get replaced. This cable worked perfectly! The wires were ordered in the same way as the original cable. The cable is a little thinner than the original but it doesn't kink like the original.

The media could not be loaded.  I bought this as a replacement for a Razer Naga trinity classic edition mouse after my rabbit chewed it. He likes to sit in my lap and watch while I game and normally he’s pretty chill but I guess he got a craving for electric spaghetti and munched through its original cable in one chomp.The cable is the correct one but the wires were in the wrong order in the pin connector. After digging the old cable out of the trash to check the color order, I was able to pry out the individual wires and rearrange them into the proper order and it worked perfectly.Shipping was faster than expected as well.I would definitely order again (and probably will, just so I have some on hand the next time my rabbit gets the munchies. )

Just like other reviewers said, you need to switch the white and green wire positions for the Trinity, but that takes less than a minute if you pop out the wire sockets from the connector. Works well and seems good quality.

Replaced my cord and it works better than ever. I believe it’s a little longer than the original. It’s threaded like the original too which I love. Saved me from buying a new mouse!

Used this cable to repair my Corsair k95 Platinum Keyboard. You have to swap a few pins on the connector on the wire and it snaps into the connector on the pcb. It works perfectly and probably the easiest fix for a damaged usb cable on many other devices.

works great after re-pinning the white connector to match the color code of the one removed

My cat enjoys chewing through braided cables for some reason - replacement cables are a lot cheaper than an entire mouse. Works perfectly on my Razer Naga Trinity - as others have said, make sure that you re-pin the connector to match your old one. A small screwdriver to lift the plastic locking tab over each terminal is all you need.

A orientação dos fios que vão no contato interno com a placa estavam invertidos, necessitei refazer as conexões para poder utilizar o cabo, após este ajuste, não tive outros problemas com o produto.Acredito que não seja culpa da loja, e sim do fornecedor, entretanto deixo o registro do problema.