ER32 Collet Set By 16th Full 12PC Set Industrial Grade

Have not had the time to test the entire set for runout but the ones I did use were spot on.

The media could not be loaded.  Like some of the other reviewers have said, I too found a few collets that had a chip (meaning left over from the slitting saw) or two in them but nothing I couldn't easily free or blow out with compressed air. The surfaces are fantastic and the TIR on my set is less than 1/2 a thou. Curiously, most come out of their individual packages ready to use but a couple have been a bit oily, not a big deal to take 10 seconds to wipe off. Wish I had more to say but they're pretty simple items which work great, are very accurate/concentric and quite honestly I'm not sure what more you'd get by going with a McMaster Carr set. Video is indicating a piece of 3/8 drill rod.

Good fit and finish. Nothing to do but use. Size marked on each collet. Tried a few, hold was good. Didn't runout, but what I could see looked good for the things I do.

I got the metric set. They came individually oiled, wrapped, and boxed. The size range is clearly etched on the face. They are well made in that I did not have to contend with burrs or imperfections. They run true, the grip hard. I’ve used them for a couple of months and am very pleased.

My chuck is not here yet so I can not comment on run out, but,the initial look over, they appear to be very well made, & finished nicely,well oiled and packaged.The only minor thing I would say is the size etchings are very faint and hard to readfor my older eyes.Anxious to try them out!

Nice fit and finish same brand as my imperial set and should fill all the gaps in sizes

I haven't measured the run out, but for a novice like me this is a great starter kit. My only wish is that they had size ranges instead of just the max size printed on the collet.

Will do what i need it to do