Electric Skateboard Esc Motor, Electric Skateboard Controller Remote 24V/36V Electric Skateboard Longboard Motor Controller ESC Remote Control Electric Longboard Esc Motor (T2 Dual Drive 300W)

The main unit works very well and delivers pretty good performance once you get a better remote control. The included remote is pretty bad as far as remotes go, it works but it feels like it has three to five distinct throttle positions leading to a more difficult ride and lower efficiency. New remotes are readily available here and on AliExpress, just be sure to get one with the battery level indicator LEDs as that’s the one I have and it feels great.

Simple wireless controller that performs well and is easy to set up... As long as you don't need directions, of which there are none. Just connect a BLDC motor or two and rotate the motor to turn on. You don't need to connect the on switch at all because it will power on via motor rotation and off when not in use for a few minutes. The wireless control is good, but is slightly more sensitive than I would want, but it works fine. Regenerative braking works well too. The fact that you can reverse on the fly is a cool feature. I ran this for 10 miles up and down steep hills on an electric dirt board that I made and the entire unit was cool to the touch which implies a decent build quality. I run this at 36v, however the capacitors are 63v implying that you could go even beyond to 48v maximum recommended voltage, but I have yet to try this. All in all, this single unit replaced 2 motor controllers that I was using in a much smaller package. My only gripe is that when one motor slips due to poor traction relative to the other motor it seems to confuse the controller a little and it intermittently reduces power to both until they are spinning at roughly the same rate. Not a big problem, but it does get your attention.

Cuando conecte los sensores de efecto hall al controlador el motor funcionaba de manera errática. El motor que uso es un 6384 120kv. El sistema de frenado me gusta mucho. Es suave y progresivo.Para instalar el controlador diseñe una caja plástica que luego imprimí en una impresora 3D. Si te interesa la caja puedes escribirme a [email protected].

This is my second one of these general "China" esc there all basicly the same, they can be found for 50$ elsewhere so only but this if you need it soon.