Atwood 31501 Circuit Board

Got the board put it in my Atwood 8525 II it fired right up. The part was said to be used packing was prior opened so it was 20 something dollars cheaper I took a chance and tried it. I would highly recommend this part I saw no signs of it being used it almost looked like the box was just bumped around from being stored.

I was experiencing an issue with my RV heater in which the heater would start, but not stay on. It kept refiring over and over. I started replacing parts according to cost, heat sensor, sail fin, etc. I decided to replace the circuit board. It fixed the problem. I wish I had started here. There are all kinds of folks on RV message boards experiencing the same issue I had. There's an equal number of suggestions to try and fix the problem. Many are quite expensive and/or time consuming. Try replacing your board with one of these. Very easy to install and it most likely will fix your heater issue.

The heater fan in my trail lite wouldn't kick on. The thermostat would just click, but nothing would happen. it had been working fine during the previous season. After checking all of the fuses and running a test light around on the board I realized power wasn't passing through the board to the fan motor. I jumped the fan motor to make sure it would spin and it did.So based on what I could figure out online the best answer I found was a faulty circuit board. I replaced it in about 5 minutes and everything works great now. Powers on and shuts off when the desired temp is reached. No propane smell either. Hopefully this board lasts as long as the original.

My furnace kept shutting down with multiple errors the safety switch (looks like a circuit breaker) kept tripping it gets a signal from the control board thats there is a problem somewhere within the furnace and shunts down your gas valve and the furnace as a safety measure after checking some of the possible causes that would cause an error I called the manufacturer we concluded that the control board was bad, this board arrived on time and installing it was a snap very simple to switch out. Turned on the heater and everything worked just as it should so very happy with this product and have heat back in the camper at last. As a note follow all you safety guides when working on your furnace to keep yourself safe but if you're familiar with electronics this is a simple fix and can save you a ton of money.

This unit would have fit into my furnace has it not needed to use the plug adapter. It must fit into a small space in the furnace for the outside cover to close. The adapter increased the height of the plug and wouldn't fit. I could have bent it but chose to find another without an adapter. Board construction was good.

This is exactly what I was looking for. The item works as described and even exceeded my expectations. They app for the iPhone works well. I may buy a few more for other applications.

This replacement board worked perfectly to repair the furnace in our camper trailer.

Our heater would fire up and then shut down almost immediately. Easy to install and cured our heater problem. Only complaint is that I ordered an Atwood part and received an off brand labeled item. leaving on a trip so I installed the part anyway.

My old motorhome had a propane Duo-Therm Furnace.Got to hate it - the pilot light kept going out.Probably caused from outside on-coming wind - creating turbulence in the burning chamber, when the furnace wasn't running.***Managed to find a free Atwood 7920-2 furnace - left in a small abandoned truck camper unit. Took a few hours to remove it.Now back in the motorhome, I did a quick test in the middle of the floor. Quickly moved the gasline over and the wiring.This furnace has a circuit board with electronic start - hence NO pilot flame.It worked. Within a few hours, I had the old furnace out and the Atwood sitting in its place.This unit has an Output Capacity of 13,680 BTU/Hr. Runs off a 12 vdc auto battery - with a 2 amp trickle charger attached.***Last winter, I spend a lot of money running two additional electric heaters - to help keep the temperature inside more reasonable.Decided to look around for a second Atwood - that could be installed where the 5 gallon hot water tank used to live.The tank rusted out and developed a 3rd hole... :)About a month ago on Kijiji - I found a used/new 2.5 gallon 110 vac water heater. Sure is nice to have hot water again... :)***With a 2nd furnace, I could get more heat at the front end of the motorhome. The gasline was just sitting there - capped off.Managed to find an old Atwood at a salvage yard - east of Calgary.It looked exactly the same as my unit, but had a slightly lower 12,160 BTU rating.Probably paid too much.***Once connected, just the fan operated - no ignition.Swapped out the circuit board from the first Atwood. The second unit was now working! Amazing.Its circuit board that came in the furnace - was toast.Started to look around for a replacement - for the first furnace - which now is missing a PCB.The original design had the wiring connector - being pushed into the side of the PCB.***The newer replacement PCBs - now have 6 vertical connector pins. Some internet sellers didn't include the required adapter - for the older style of Atwood.This unit on Amazon did and the price was the best I could find.***The package came within 3-4 days. Put on the adapter, connected the wiring harness and turned it on.It's been working perfectly ever since...***Eventually I'll need to buy another newer PCB - when the other one finally gives up.Guess I'm now ready for Jan/Feb - when the temp sometimes reaches down to -30 C, if not lower.

Perfect delivery perfect fit furnancecfun well

The furnace in our RV was damaged due to mice. My husband narrowed it down to the board and this was a perfect replacement.

My atwood 8535 would light 3 times in a row but not stay lit then would lock out. Tried a new flam sensor with the same results. Replaced the circuit board and it now works as it should

It took 5 minutes to install after removal of rv furnace. The furnace fired up first try and has been awesome ever since.