ZERK GREASE FITTING ASSMT. 132 pcs .STRAIGHT 45°, 90° SAE/INCH ZINC PLATED STEEL TECH TEAM

Fit where I needed them

You should definitely buy this I only needed one but it was cheaper to buy this whole big set then it was to buy a small package at the store just to do it little job

They aren't staying connected to the Grease gun nozzle when even the 20 year old ones on the equipment do lock on very tightly and can't be popped off by Grease pressure. I did use one after drilling out the spring and ball from the hole in the threaded end to successfully replace the airblower's nozzle after the old one blew the rubber piece off itself today. That's the best use for them so far every one that I've used to replace a Grease zirk has not locked on to the Grease gun nozzle and just wastes Grease and time

You need this if you maintain your own equipment.

The threads on the the few I needed fit my old jeep OK, so threads are SAE. The hex section used to tighten them, however, is metric. And, the hex is smaller across and thinner than the ones I replaced. On a couple, the threads don't tighten up before they bottom out and the hex wanted to continue into the threads (which they won't because you lose the hex into the threads.) I almost sent them back but they did mostly work. I suggest you go to a parts store and buy better quality. I can't recommend these.

You can never have enough

Well made and just what I needed. When working with equipment you always encounter broken and damaged grease zerks. With old equipment some grease fittings have to be replaced to enable greasing. Good addition to my shop supplies. Will purchase from this company again. On to the next project.

Not very happy with this delivery the box was broken inside the Amazon bag and all the grease fittings were all over the place. Now I have to sort all the grease fittings one by one ..... should send me another package for all the headache