Bonbo 4Pcs Garage Door Torsion Spring Center Bearings ID 1" x OD 2" Deep Groove Ball Bearing

Worked great for the springs and the rod very satisfied!!!

These are 1” I.D. Sealed with 1 snap ring bearings useful for many applications, I used them on my 36” Toro walk behind mower to replace the old frozen 1” I.D. Wheel bearings at a fraction of the price over other available flanged bearings.

These sealed bearing are much smoother then the original open bearings. I adde an extra bearing to the center of the shaft, on the mount between the two springs.

I'm using this bearing for an entirely different application than what it's intended for.My use is in a harsher environment than a garage-door opener would be used. My use exposes it to the somewhat corrosive vapors of photographic processing chemistry. I'm using a pair of them to replace the plastic sleeve bearings in an IMG / Drew Refining Silver Recovery Unit.In my commercial photo labs, I've had nothing but trouble over the years with poor bearing life in the rotating cathode drive system in electrolytic units. With a pair of these bearings and the modification I made, it's an easy job to replace when necessary.

Great fit for my 1986 John Deere 318 front wheel bearing SAE 1" x 2". John Deere changed their front axle spindles mid year in 1986 from 1" SAE to 25mm this effects the late 316, 318, 330, 420 and430 garden tractors.Hope this will helpDan R.

These bearings are way too small. They're not one inch inter diameter. Two inch outer diameter, the inter diameter will not even fit. The, hole is smaller than one inch.

Product was an exact replacement for my JD 400 front wheel bearings. Shipped in timely manner, would buy again.

Item would not fit 1" garage torsion bar. Tried both sides and two bearings, could not even get it started on pipe. No issue with springs, nylon spacers, or bracket bearings. Cost me several days of work because of the poor specs. Beware that bearing ID is not sufficient for advertised application.

pour porte de garage

Good quality