10 PCS Basswood Sheets 1/16 ×12×8 Inch,Unfinished Plywood Craft Basswood Sheet for Cricut Maker

Had minimal imperfections worked well for pyohraphy

Overall, I gave it 3 stars. Some pieces cut beautifully, others did not, as you can see in the photos. It became frayed on the more intricate cuts, which I then had to use an Exact-o knife to cut the frayed pieces off. That was very time consuming and frustrating. I still had some little frayed pieces after using the Exact-o knife, so I had to use a nail file to smooth it out. I also used a brand new knife blade with my Cricut to make these cuts and I had to cut most of the pieces about 15-24 passes! Give-or-take the intricacy. You can see the final product in the pictures. Overall I’m happy with end result.

This is a good value product. It is lightweight, fairly sturdy for its width, and arrived fairly flat. I had a couple of pieces warping slightly, but they went through my Cricut just fine. My only complaint is that they are not the advertised size, they are about 5mm smaller in width and height. This isn't a huge problem, but it did force me to recalibrate the size of my project slightly. The edges sanded down easily, with minimal splintering, mostly where the original cut wasn't perfect. My larger finished pieces (pictured) were flexible throughout but held up; the legs of smaller pieces (width of 1cm) broke under a bit too much pressure in, but I wasn't surprised due to the size.

Nice product, but it is slightly smaller then advertised.

This is my favorite material for laser-cut photo jigsaw puzzles. Very little charring (with the right setting); there's no need to clean the edges. Sturdy enough for making quite tight-fitting pieces. The wood texture is pretty consistent throughout, and also consistent from sheet to sheet, making for consistent cuts. Photos can be laminated on it using spray adhesive.It also takes laser engraving well.The surface is pre-sanded to a reasonable smoothness; I can generally use it for small woodworking without further sanding. Be careful of trying to sand it further, because the veneer is quite thin and you can sand right through it.Occasionally you get a few that are warped. I use those sheets for small pieces where it doesn't matter.My main complaint is that I wish larger sizes were available.

Some reviews said it worked on their Cricut machine, but I couldn’t get it to cut through all the way even after running through 15+ times. No complaints with the actual product but if trying to cut on Cricut I would try something different

Unfortunately after 18+ passes(original job set it to 11 passes), it still wouldn't cut all the way through the wood for a basic circular ornament shape. Pressure was even changed to a heavier setting.

I read through all of the reviews and figured this was either going to be great, or absolutely terrible. It wasn't either.I bought these to use with my Cricut Maker 3. As you can see from my pictures, this is definitely not a solid piece of wood. Each side has a very thin, smooth piece, which meant that I could not seem to easily cut through this side directly against my mat. Despite adding extra cuts, it still resulted in the back layer basically peeling off. :-(I won't buy it again, so I wanted to post something a little more middle of the road.