Rough CountryFront Track Bar Bracket for 1987-1995 Jeep Wrangler YJ - 1163,Black

Bracket is thick and strong....So as you see from photos I traded out the 9/16 small bolt for a 5/8s bolt with a locking nut to beef it up and to have better confidence in the nut not falling off and I placed a large washer for the track bar mount for more stability. All this was not necessarily needed. I only did it because I will be beating it with no mercy on the trails.'95 YJ

The other choice didn't look as robust as this. If you have a Wrangler with 4" or more of lift, the Rough Country Track Bar drop bracket corrects the alignment of the track bar, bringing it more parallel to the ground at rest. This way the suspension isn't constantly pulled to the left. It requires you to drill into the reinforcement webbing around the passenger side vacuum axle disconnect but the extra stability is worth the extra work. The other brackets I've seen (and almost bought) look like they would just bend with stress rendering the track bar useless. An adjustable track bar would just push the suspension to the left under compression. This bracket is a better value and is working quite well on my YJ Wrangler with 2" Pro Comp springs and Full Traction 2" shackle reversal.

Way better than making one your self Fit great and is made out of almost 1/4" thick steel plus came with all the hardware.

Did the job, but came with no hardware

I was having an issue with my 93 YJ pulling to the left, if slammed on brakes or hit a large bump. This started after I install 1" shackles on top of a 2 1/2" spring lift. This relocation bracket moves the track bar straight up 3", back to near factory spec. The steering is now good as new. I couldn't believe the difference. The bracket is very well made and was about a 20 minute install.

It does the job well for which it was intended. My only complaint was that the hole in the center that goes over where the trac bar used to mount was not big enough, and so you would either have to have a huge drill bit to enlarge it by quite a bit, or do what I did and put a few large washers purchased fomr a hardware store behind it. This may have just been the design of my particular axle on theis 1987 wranagler YJ, so It may not be an issue on later models

Good quality part. it stopped the bump steer I had on my jeep at highway speeds. Much safer ride with the drop pitman arm I also installed.

Works great and was not hard to install. High quality very well made.