Readylift 69-4510 2.5" Smart SUSpension Technology Lift Kit - Xterra/Equator

Fits great and looks awesome. From the package u can till that this product is a good quality.Although i had to change front upper ball joint to extended once to increase the clearance from the suspention bucket.

This kit is great. I don't think I found anything else as good for the money when I went looking for a kit.Installing the kit itself is fairly easy, but it takes a bit of time. Watching the install videos gives you a very good idea what it will take if you don't have corrosion to make your life more complicated.There are a few things that some people might not anticipate when planning to do this themselves. The first thing is the need for a front end alignment after install. Yeah it costs money, but it is absolutely worth it/necessary in my experience.Then if you are in an area prone to rust, you might get slowed down by bolts seized into the metal sleeves in bushings. I was able to get the stock rear shackles unbolted and out in spite of them being swollen and a bit welded by rust, but had to remove the two plastic sides of the rear bumper on my 2012 Nissan Xterra to get good enough access with a breaker bar and impact. That wasn't too bad, just a little time consuming.The worst you might run into is what I dealt with on the front lower control arm bolts that need to be replaced with the new cam bolts that come in the kit. The back bushings on both sides had the original bolts corroded and seized into the steel sleeved inside the rubber bushings. I had to use a reciprocating saw to cut the ends off to get the bolts and bushings out. If that happens to you then you will need to either replace the bushings or the entire lower control arms. I opted to replace the bushings because I could get those quicker than control arms and it cost less. However, getting the old bushings out of the control arms is a bit of a battle. Just replacing the lower control arms bushings and all if the much easier way to go and isn't a huge expense.I needed to contact the manufacturer support folks for a bit of help with some parts I misplaced. They were great.It turned out that the shop where I went to get the front end aligned after my install is a dealer for ReadyLift and the folks there told me they happily install a lot of them.I'm back on the road looking so much better than stock with ride pretty close to stock. I couldn't be happier.

After reading on lifts for my truck for months on end I finally decided to give one a try and this one was the one I tried, I installed this lift myself witch was not easy but doable and it ended up great I love it I know that it says that this will not work with pro 4x vehicles as most other lifts but this one did work and I’m Verry happy with the outcome of this I would suggest this to anyone who wants there truck to be higher than stock

Managed to install the back side lift, failed to install the front side by myself … taking it to a mechanic next week to install … will update accordingly.

Review is for install since I haven’t driven the truck yet, the parts are all good it installed fairly straight forward however i did need to pit on new lower control arms on both side due to the cam bolts being stuck had to cut them out with a sawsall. My only gripe so far is that the truck does not sit level it is 1” lower in the rear than the front, not a huge deal but it isn’t level. 2016 crew sv.

Package came fast and the product is very good quality. Installation took about 4 hours on my 19 pro4x and the ride is the same as factory. But as stated in the description the pro4x will not be level with this kit and my front end is a little bit higher than the rear but some 1 inch blocks will solve the problem but I knew that before ordering so its not an issue.I would recommend this kit for anyone looking to get some lift and not break the bank