3M Particulate Filter 5P71, P95, 5-pairs of Filters

OE replacement filters. Fit and performance are as expected

In our large Green Valley woodworking shop, these filters and the 3M P95 mask they attach to, remove everything that cause my sensitivities to act up. Our shop has excellent air handling equipment but still, like in all shops, and when working directly with the machines, particulates can still be an issue resulting in a drippy nose or worse. This mask with the filters remove all of the bad stuff. The filters last a long time before needing replacement - in my case about 6 months before replacing the filter. In my view, the 3M mask with the replacement filters are much less expensive with better results than the paper masks we usually wear as woodworkers. Excellent choice for anyone. Thank you Amazon and 3M for this inexpensive and quality product and for the available replacement filters.

Excelente, igual a los originales

IT SHOWED UP QUICK AND WORKS GREAT

Received package and the filters were loose and not in a box which was strange but they work well.

As most have mentioned these are great filters and the price can't be beat as compared to buying from a brick and mortar store. My setup for this is as follows...- 3M 5P71PB1 6000 Series Particulate Filter P95, 10-Pack- 3M 501 Filter Retainer for Use with 5N11 and 5P71 1 Each- 3M Filter Adapter 603, Respiratory Protection System Component (Pack of 2)- 3M Half Facepiece Reusable Respirator, Respiratory ProtectionEverything fits like a glove and works very well together to keep my lungs safe. If I need protection from organic compounds I can easily add one under this.

I use a 3M 6300 half face piece respirator. To it, I connect a 3M 6003 Organic Vapor/Acid Gas Cartridge. The 6000 series particulate prefilter does not connect directly to the respirator. The 6003 cartridge makes the connection to the respirator and then the 6000 prefilter is put in the front of the 6003 cartridge being held in place by the 3M 501 Filter Retainer. There are particle filters such as the 3M 2091 that do attach directly to the 3M 6300 half face piece respirator. I use them too. In-between jobs, I place my 6003 cartridges and the 6000 prefilter in separate doubled up Ziploc bags to keep them as clean as possible.I have been using this particular half mask for 42 years and I've not had any trouble with it or the filters. Not the same one mind you, I've had to change them out when they become worn and tattered. But, I always buy the same mask and filters. I'm quite sure this mask setup has saved my lungs from becoming damaged over the many years I've used it. I mainly spray epoxy, conversion varnish, post, pre catalyzed, and nitrocellulose lacquers, water based finishes, and even the occasional oil based primers and paints. If my respirator is working properly, I smell nothing. I know it is time to change my filters when it becomes hard to inhale.I will continue to stand behind 3M filtration products.David F.

I purchased these to replace the ones in my 3m mask. They fit as intended and seems to filter out the fumes as promised.