UK Plastics Tile Levelling Twister System 2mm - Twister Nuts 100 Pcs (100)

Fantastic they are wide and solid.

Gave good results. As you tighten the red disc on to the spacer, the tile can be seen slowly move to the same level as the rest of the tiles. Only problem is most of the spacers do not brake off when knocked off. They remain between the tile gaps. I found a way around this problem. Just grab the spacer with a pliers and whilst pulling, just hammer the pliers. This gave a clean brake.best results. Will buy again

Started my tiling using the Vitrex LASH system but this is so much better for levelling, especially if you aren’t doing it all in one go. Just be careful tightening them, it’s very easy to snap them going too far

Good product and definitely level slabs and tiles, however they don’t always snap low enough to not see after grouting. Bit fiddly to snap the ones that break high.

As i said dont think they were meant for 20mm thick tiles due to the round part of the screw being still between the joint,but the principle of the system is sound

When I purchased the tile leveling system, I thought that is a complete kit, but there are no Nuts.I had to purchase it separately. I didn't understand that from the description

They work well but the tabs bought separately could do with being longer .

Inadequate for a 28mm tile. Did not break off in the way intended & took a lot of unexpected work to remove spacers.