Thermal GrizzlyMinus Pad 8 (100x100x1.0mm) - Self-Adhesive Cooling Conductive Thermal Pad - Elastic and Adaptable Silicone Thermopad CPU/GPU/PS4/PS5/Xbox

Worlds best pc thermal company. The pads brought a out of control RTX 3090 Below RTX 4070 Temps. From 91-98c to 68-72c if you need pc thermal solutions you need Thermal Grizzly.

Used these on the RAM chips inside my Xbox One X to replace the cracked factory stuff. Since doing this, I have not had the Xbox randomly shut off on me so the product clearly works. The installation was very easy, I’d recommend using a razor blade to cut it. I used scissors and while it did work fine, a razor blade would have been better

Worked perfectly for my Xbox one x. Great results, better than factory. It is now a silent machine. Was easy to work with, I cut it with exacto knife easily. Was not real adhesive, but plenty for my application, don't think you would want it real sticky anyway. It was such a good experience, i just had to leave a review!

Item:- Product is as expected, knocked 6C off of mainboard VRM temps, 5/5People:- It should be habit when shopping on Amazon, that you read the reviews AND look at the current seller that is selected- I did this, and realized that people were getting possible fakes from individual sellers because they just clicked 'add to cart' without lookingProduct:- I purchased mine from Titan Rig, the package looked legitimate and was sealed, but did not include the authenticity card as others have noted.- I think this package of Minus Pad 8 does not normally come with the CoA, though my smaller pack of Minus Pad 8 did.I don't think others have received fakes in this case, but you should pay attention anyway.Bonus points for supporting smaller retailers!

Very good at dispersing heat. Applied to the back of my RTX 3080 FE and although the VRAM still thermal throttles, my ETH mining has rate increased from 65MH/s on avg to 85MH/s (reported) on average topping out at 120MH/s (actual) on the high end!

I bought this to replace the stock thermal pads on my Gigabyte Z370N WIFI ITX motherboard. I cut a strip for the VRM heatsink as well as the M.2 SSD heatsink. The VRMs now take significantly longer to heat up and temps overall are reduced 5-20C depending on the CPU load. The 960 Evo SSD was throttling due to high temps (75C+) with the stock thermal pad but now stays much cooler (65C or less) and no longer throttles. This thermal pad is expensive but did exactly what I hoped for and is far better than the cheap pads Gigabyte uses on this particular motherboard. I wish I had swapped the pads out sooner!

Hey here. Used this on a 1080 FTW2 in my system that I’ve had for a year and had quite trouble. I bought this and some NT-H2 to redo the thermal paste and now I’ve got leagues lower temperatures. Down by nearly 10 C in some cases but then again, the last time I opened my card I screwed up a few of the pads and I found that my last thermal paste application was the worst I’ve done so...A bit of a hassle since the FTW2 card has so many small and thing point for thermal pads but this should be completely worthwhile. Maybe help with value too when it comes time to flip the card. It’s good stuff and I had a little left over but couldn’t get the back of the VRMs on my card through the backplate, everything else is new pads but to be fair, that is one massive pad they put there.

Is pricey but it really helps keeping temps down. I used this on the heatsink of an xbox with great results...it really extends the lifetime and serviceability....