Mining Rig Frame - Steel Open Air Miner Mining Frame Rig Case - Mining Frame Rig Case Up to 6/8 GPU for ETH Ethereum Bitcoin Mining Accessories Tools

This is a total piece of junk. No way you'll get 8 cards on this rig. If your able to squeeze 6 cards (doubt it) plan on your GPU's running extra hot due to no spacing between. Don't plan on have more than 1 PSU either. DON'T WASTE YOUR MONEY. KEEP LOOKING

Warning!!! This frame is not what you might think it is. It does not provide adequate space/air flow for 6 GPUs, much less 8. That's not even considering where you would put your secondary PSU if you running more than a few cards. While the picture looks similar to the normal frame of this style, there is NOT room for a second power supply. Unless you want to put your second PSU on the GPU rail and only run 3-4 cards, two PSUs will not fit. It seems that every time I pay a little extra to get Prime delivery for this type of frame, I always get something of lesser quality.

Now this I don’t understand. They have the Motherboard set to were you plug in all the cords on one side. Then all the Graphics Cards all the cords on the other side. Why don’t they just have it to were all the cords come out the back for good cable management! Works great though. Does the job. And for the price. I can’t complain! I will buy again. But will be doing my own mods to it. And going to on this one as well.

This frame could hold 8 GPUs but only if there is no space between them. It is ok for 6 GPUs. Be advised that this is a small frame. Only room for 1 PSU and just barely fits an ATX motherboard. Assembly is fairly easy but comes with the most basic instruction diagram. The frame is sturdy. With proper cable management it could be a compact 6 GPU mining rig. It can fit 4 120mm fans across the front. Do not try to water cool anything with this frame, there simply isn't enough room. Overall it's a good, little, sturdy frame. I only gave 4 stars because of they say it can hold 8 GPUs which isn't really an option.

Looks elsewhere. Pretty junky, fans to sit well, no instructions

This frame is a nice little setup and went together fairly quickly.Overall pretty sturdy. Only had one issue, one of the holes got stripped pretty quickly so becareful you don't over tighten.Improvements: You have to think about what screws would go where or come back to these picture to find out. I would personally re-write the instructions to clarify what screws go where and maybe better pictures. However if you put some thought into it and look at these pictures on amazon you will figure it out and when you do it goes together in 5-10 mins.

Easily assembled, only need one screwdriver, sturdy. Only issue is with the included instructions. Print is super small. Not complicated to figure out so instructions aren't a major consideration.

Easy to assemble. Instructions aren’t helpful, just used common sense. Good Saturday frame for starter rig or small card rig such as RX 580. Holds up to 6 I personally wouldn’t do 8. You can only fit one power supply with the motherboard. Only fits 4 120mm fans so keep that in mind when buying a 5 pack. Also came with a power switch. Took about 15 minutes to assemble.