Bosch HS1418 5 In. x 11 In. SDS-plus® Bulldog™ Floor Scraper

Very well made. I used it to remove strong glue from a concrete slab. Did a great job and even though I beat the edge up, I will put a new edge on it and it will be ready to tackle the next job it is not designed for.Well worth the money, super time saver!!

I used the general demolition bit to remove the ceramic tile off the floor and I used this bit to remove the Thinset. Worked fantastic! This bit will remove more thinset faster than your general demolition bit. Save your time and spend the money

Worked perfectly and did the job

Purchased this to scrape up the hardened Silka expansion joint sealer/filler that was used to fill concrete expansion joints before applying an 1500sq/ft epoxy floor. Worked great and for the 300ish feet of overflow sealant to clean up that would have been done with a razor, it was worth ten times it's price. Used in a Milwaukee M18 SDS-Plus Rotary Hammer Drill.

Good quality at a good price.

Got this to remove stubborn thinset and grout off concrete foundation that I couldn't get off with other tools. Scraper went through it like butter. Section in picture took about 3 seconds. Spraying small sections with water beforehand, drastically cuts down the dust factor. Bosch thank you for making this quality bit!

This is a SDS-PLUS tool bit that quickly removes adhesive and thinset mortar from flooring substrates and flat surfaces. It is NOT a cold chisel, that is, it is not meant to chip, form or break concrete, stone, block; it is meant from scraping. I used it to remove foamboard adhesive from CMU block ("cinderblock"). It worked very well and quickly pealed the glue off. I had to cold chisel and pry the foam board off of the block: it broke into pieces because the glue bond was so strong. The Bosch HS1418 bit made cleanup of the block a snap.

I used this to chisel thinset and tile in my upstairs bathroom. It worked great and I could not have done it without this tool.