FIERYRED Smoked LED Tail Lights Compatible with 2018-2024 Jeep Wrangler JL Reverse Light Turn Signal Lamp Running Lights

Had reservations with initial purchase at such a low price point in regards to actual brightness of the brake function. I am completely satisfied with that aspect of them. They do not come with instructions. There are videos on YouTube that made this an easy 10 minute installation. You do have to remove the brackets from the OEM lights in order to fully secure these with the factory hardware. The ONLY thing that I do not like is the fact that there is no reflector which would make these safer when parked. There have not been any issues with any codes or flickering. Overall I am satisfied with the quality and look of these on my 2018 JLU. I do recommend for an easy and aesthetically cost effective upgrade.

Nice product. Easy to install when you figure out how. First off, you will remove the back on the existing OEM light and mount it to the new LED light. Second make sure you also remove the metal clip that is on the OEM light to move to the new LED light. Second, you must attach the clips included with the metal bracket to the bracket on the side without the holes. The resistor will be screwed onto the metal bracket and must not be near any wires. It may reach 300 degrees when the light is in use, so keep all wires away. The edge with the metal clips attached now will be squeezed to a metal edge from the sheet metal of the body panel inside. I'll upload photos soon to show what I mean.It's very very simply once you figure out what to do since no instructions are included with the lights.Well worth the money compared to the 375.00 each for the OEM Mopar lights.

It looks beautiful and the install was super easy. Nice and bright and so far a heck of an upgrade over stock. I just installed these today so I have to use them for a bit to see if they hold up. But rest assured, I will update this post if anything goes wrong with them! Otherwise, assume they continue to work perfectly!

Item had to be replaced twice and needs to be replaced again. Lights keep going out on this item not a good buy. Looks nice but does not last long. Rating should be only one star and that's because it looks nice only

Posting this for 2 reasons: 1. Where to put that resistor bracket 2. Light dimensions1. The install is easy, just pop the cap on the inside of the jeep next to the roll bar with a flat head screwdriver to get to the retention bolt. Remove plastic bolt with the torx tool that came with the Jeep. When you get the light out, disconnect the wires, and remove the 3 screws from the extension bracket on the original light and then you’ll place it on your new LED light. On the new light, I mounted the resistor bracket through the lower peg, and attached the resistor with just one screw, hanging down. The resistor gets hot, so I put it as far away from the wires in the light as I could. On the passenger side, I mounted it in the same place, but horizontally to avoid interfering with the tailgate arm.2. This light is wider and flares out compared to the factory halogen light. The fit and finish is okay. It splits a little on the side if you tighten the retaining bolt too much. The panel market does not run with the DRLs, only when the lights are on-on.

Pretty dope for the price , worth the money . No instructions included but it’s easy to install. Pretty much plug and play. Not that bright during the day but at night is fine. For the price you can’t beat it . It’s definitely worth it if ur just want something different and don’t want to spend a ton of money

Nice set of lights, Easy to install. But… I purchased these lights specifically for the turn signal being a different color flash on the outer rim. However it’s the same as the brake function only it flashes. Disappointed.

Fits perfect.Works good.Looks cool!!

Parfait

Parait bien mais code erreur dans le tableau de bord de mon 2024