Taylor Precision Products Classic Design Freezer/Refrigerator Utility Thermometer (2 PACK)

I like that it shows you where your fridge temp should be. My only complaint is the suction cups. Not sure if its me or the cups but they don't seem to want to stay put for long. Wish the cups were designed better so it would be easier to mount and remain but I guess you can't have everything.

These work well except for the suction cups. I have not been able to use the suction cups in either the refrigerator or the freezer. They just fall off. The thermometers work well and I just lay them down in a clear area.

Its a nice Taylor Thermometer but I was slightly disappointed by the suction cups. They don't really stick to the internal parts of the fridge. Other than that the temperature is easy to read. It is clearly written what is acceptable temperature. I don't have to worry about replacing batteries. I really like it!

I bought a set of 2. Only one of the set worked. I had to get a refund for the other one. The one that is good is just fine.

I bought two of these thermometers and after using them in two refrigerators for about a week, I noticed that if I put them side by side, they had different readings. So one of my refrigerators is OK and the other one is 10 degrees too warm? Put both in and they were still off, so it's not the refrigerator. A third thermometer (not a Taylor) confirmed which thermometer was accurate. So I gave three stars because one worked OK.

While it's compact and attractive, useful for freezer/frig, the suction cups are almost worthless. Especially in the freezer where they hardly hold at all.I suggest adding a hook so it can be hung in a freezer.

Bought two: one for the fridge and one for the freezer. 3 out 4 suction cups worked, the last one would not stick. After a few days, the thermometer fell on the ground from about 5 feet (suction cup gave up so I had it propped in a nook on the side) and it broke (the temperature line was not usable). Not very sturdy...

Bought two of these. Test them in the 'fridge and freezer for consistency. Once I was satisfied, I split them up. The one in the 'fridge is working fine. The one in the freezer failed in a week. The red fluid is across the entire scale and is separated in the middle (3 gaps). I tried to heat it up in hot water to get the red fluid to re-join (and then cool it to start over), but the fluid doesn't seem to be moving at all. It looks like only 1 of the 2 will be useful. Disappointed.