4" Yamaha G2 G9 Lift Kits, 4 Inch Golf Cart Lift kits for 1985-1994 Yamaha G2 G9 Gas and Electric, 4in Front & Rear Suspenison ATV UTV Raise Block Kits Fit up to 20" Tires

The Lift was much better quality than the lift purchased previously. I only had one item I had to modify on my wheel spindle to make the bolt fit. I had to widen the hole for the steering arm mount slightly to fit the bolts. I do wish it came with new plates to mount the springs and new bolts/nuts for the mounts for the steering/spring mounts. I would guess that would raise the cost of this product though. The metal appears to be plenty strong enough for the application and the welds look to be solid.

Everything is well made and can’t beat it for the price. High quality material. There was a shipping issue that wasn’t their fault and they made it right immediately. Instructions were clear and the pictures were helpful.

6inch lift kit fit good on my 1999 Ezgo golf cart, just had to bend the brackets to connect the original shocks about 1/2 inch but no problem. Golf cart looks and rides great.

Was a very easy install with very self explanatory instructions. Decent quality parts for the price.Edit: after putting miles on the lift I would recommend putting a tack weld or 2 on the front control arm brackets as they will shift side to side a little bit since the holes are slightly larger than the bolts are and cause the tires to rub

Had issues with rear lift. Brake line attachment makes the lift not work. Had to remove brake assemblies and swap right to left and vise versa. This allowed the brake assembly to be rotated 180 degrees and have the line attach on bottom and not interfere with lift.Also had to drill a hole bigger in the passenger side sprocket to allow for bolt to fit for the C bracket to attach to steering gear box.Definitely not as easy as described

To lift my ranger over the over the stumps going to my stand. Works great.

Would have gave 5 stars if the instructions were a little better

I installed the kit on a 2018 EZGO TXT Elite. Customer service said it would fit. I started the project with high expectations, starting on the rear. Everything was going great until it was time to put the first riser on. The holes lined up perfectly however, the riser hit the brake cable bracket. Lucky I had an angle grinder with a cutoff wheel. After about 20 minutes of modifying, I was able to get it to fit. Same issue both sides. The driver side I also had to reroute the brake cable to make it long enough. The only issue with the front was I had to drill out the two holes for the steering bracket mounts on the spindle.I would not recommend this kit unless you are mechanically inclined, and have the tools to make the modifications.