200 Psi 1/8" NPT Thread Pressure Transducer Sensor Pressure Sender Stainless Steel Oil Pressure Transmitter for Car Automobile Motorcycle Boat Oil Fuel Air Gas Liquid Water Pressure

Good

Worked for about 30 minutes. Pegged at 200 psi all the time now

Bought 1 and tried to wire it. Using an OHM Meter and the product diagram, the one sent to me had the BLACK wire connected to VDD and the RED wire connected to GND. Installing it either way (according to COLOR or DIAGRAM) it didn’t work.

Dear All buyersDO NOT purchase this item.I have at this moment 4 pcs in my collection, all defective.Some arrived defective other failed within 15-30min of use despite correctly connected, voltage, pressure and temperature.A bitterly regret having spend money and time on this product which is wasted.// Thomas, Engineer by profession and hobby

bought to replace old sensor that still worked was just wanting to replace everything with new parts during rebuild process, went to start car sensor reads 0psi put in old sensor and it worked perfectly, will not purchase from vendor again.

I have tested this multiple times and no matter what, the sensor sends a constant .062v signal. I have another brand of sensor wired in next to it on the same pressure source and one works properly, this one does not.

I have a Pico scope but can't afford the WPX500S at the moment. This transducer is fine for getting compression readings but it isn't fast enough for diagnosing. For the price tag I have no complaints.

Hooked up mechanical gauge when this one seemed to be low , oil pressure on digital gauge was reading 12 psi while mechanical was reading 50