Light Up Your Journey! 🚗✨
The SYLVANIA 2357 ZEVO LED Amber Bulb offers super bright illumination with high lumen output, making it ideal for park and turn lights. With a limited lifetime warranty and advanced thermal management, this bulb ensures reliability and safety on the road.
R**S
You also need load resistors to make them error free
I installed this on my Hyundai 2016 as the brake light. Looking from outside it's working, but the computer keeps throwing error code because it cannot detect the LED bulb. You need a load resistor to make it work. But the lighthouse does not have enough space for the load resistor so I either have to throw away the LED light or live with the error code every time I drive.
T**D
2013 Hyundai Accent GLS - Does Not Fit
Although the Amazon website identifies 2357 ZEVO as a replacement for 2013 Hyundai Accent GLS it does not fit; note in uploaded image the pins are offset and cannot lock the bulb into the socket.I was able to get the bulb wedged into the socket to test it. Using the 4-way flasher the bulb flashed normally. Using the turn signal the bulb flashes rapidly.I have read some reviews where users find rapid flashing LED turn-signal bulbs acceptable. Understand this, all LEOs recognize rapid flashing bulbs as defective equipment somewhere on the vehicle and now you're subject for an impromptu vehicle inspection.
B**B
Fantastic choice for your turn signals!
Fantastic LED turn signals for your car or truck. They are bright, and they reduce electrical load on your vehicle. Just be sure to use these inside DOT approved enclosures with the texture in front of the light, as the light may be too bright if used in some aftermarket light enclosures that have a completely clear lens. I installed these in a '93 Suburban so I also had to swap the flasher relay for an LED friendly type, then I was all set.
J**.
Poor quality control
First of all, I purchased these to replace the bulbs in a Hyundai Sonata that has been plagued with tail light problems. The light housing get hot to the point that it melts so bad the tail light assembly needs to be replaced. So I wanted to try an LED option.The soldered connecting points a the bottom are NOT at the same height. The pack came with two bulbs and one of them had very little solder to make contact with the light socket and only way to get it to work was to add more solder to the bulbs connector to make it work. For $20 light bulbs from this manufacturer this sould not be an issue.If you purchase these bulbs, just be aware of the issue. I have seen other reviews with the problems. Only time will tell how long they will last and hopefully it will finally solve the poor design problems with this vehicle.
H**N
Better Than Stock Bulbs
I installed these LED Lights in to an L-5030 Kubota Tractor. They are a substantial upgrade in brightness but are not as good as I was hoping for. I would say they double the length of brightness. They are much easier to see when approaching in a vehicle. These lights being brighter are also safer for day and night travel on the road. I also installed LED Front Headlights, Rear Brake Lights and Flashers. Again they are brighter, but not as bright as I wanted, and again with more viability, the tractor is overall SAFER to Drive on the Road!!! I also installed an Overhead LED light to the Roll Bar, and between the two I now have excellent viability at night. Longevity is TBD. August 2020.
B**E
Likely Need Capacitors To Work Correctly
Bought For rear lights on a 2006 Tiburon. Had an issue where left brake light would stop working with headlights on. Changed reg bulbs 3 times in 3 months. Great replacement. However solution to get the led bulbs to work with full brightness you will most likely have to wire in and add a 25-50 v capacitor to each brake light in order to get lights to work normally with the new led bulbs. The capacitor will get as hot as the regular bulb would so use care where mounting / wiring. In the end i had to replace brake light socket and avoided capacitor by retuning original bulbs to the car... leds to the drawer... all works fine now.
K**N
Worth every cent¢
Installed these Read ZEVO LED bulbs in my taillights on 2004 Aprilia Atlantic 500. Amazon says it doesn't fit my motorcycle which is not true.Pros•Fitment is perfect•Much better than stock incandescent bulbs. (On a motorcycle that is a good thing for safety)•Uses less watts/amps. This is a good thing because it puts less stress on the bikes electrical system; freeing up power for other accessories.•High quality LED bulbs with good heatsink.Most other cheap LED bulbs lack a good heatsink. Remember, Heat ls what kills LED's.Cons•$$Cost$$$. But you get what you pay for. It's worth the cost.
M**N
Works
I have a Hyundai Elantra 2011. Used the red bulbs as my brake lights. They install fine and works with no issues. One of the concerns I had was that the LED would be too bright and that it would look like the brakes are always on. However, that wasn't a concern with these. These light up pretty bright and was noticeable when I hit the brakes. I would buy again and will update review it anything happens.
S**E
Satisfait
Très brillantes. Il n'y a pas de lumière directement visible de l'ampoule; au lieu toute la lumière est envoyée sur les réflecteurs, ce qui d'une donne une illumination plus égale.-1 étoile car j'ai reçu l'ampoule blanche au lieu de la rouge commandée.
S**C
Great bulbs
Your browser does not support HTML5 video. Amazing! Bright/nicer red and instant on!On the video: I have a reg bulb on the left and the LED in above the Forte 5. You'll see that there is no delay on the led when pressing the brakes.
M**D
Four Stars
Amazing
Trustpilot
5 days ago
2 months ago