🔥 Ignite Your Grill Passion with Every Meal!
The Direct Store Parts DA109 is a 3-pack of stainless steel burner replacements designed for Charmglow and DCS gas grills. Each burner measures 19 1/8" x 6" and is crafted for durability and performance, ensuring your grilling experience is top-notch. Perfect for those looking to upgrade their grill without the hassle of complicated installations.
F**N
Heavy gauge product-better than original
The burners are better made and if a heavier gauge than my original ones which probably cost 3x more. Very impressed with getting such a well made product for a very reasonable price. My only recommendation is to include a better dimensional sketch as the location of the bracing tab is shorter than the overall length. I was able to bend it back and get mine in.
M**D
Good Enough
I ordered these replacement burners for my DCS 27 series. I only needed two but couldn't find...so this triple set will do. They're a lighter gauge than the originals but ok for now. They slipped right in with no serious issues. The bottom (gas) side rubs against the igniter housing but no problem. The top (horseshoe) claws don't fit perfectly into the support brackets so there's a bit of rocking side to side...but again no serious issues. So my DCS grill has a second life. I will report back later with a long term review/update. Let's get grillin!
D**.
Made my DCS BGB-30BQN like new again! Some modification required.
Ordered these to replace the old original rusted out burners on my BGB-30 grill. For the price, these cannot be beat but beware that some modification may be required. Both burners required the rear tabs that hold the burner in place to be modified. The tabs on these were about an 1/8 of an inch too close, so I took my dremmel and cut out a notch on the tabs that would allow them to seat properly. The left burner immediately fit into place and worked like a champ.The right burner was a big PITA. Not only did I have to modify the rear tabs, but the front tabs were causing the burner to not make proper contact with the gas orifice. Once again I took my dremmel and about 6 cutting wheels to cut about an 1/8th of an inch from the front of both tabs. After that, the burner slid into place.Overall for the price, I can't complain about the necessary modifications.
D**N
Well made
These although didn't fit my bbq( im sure they fit what made for) they where very nice quality.
L**Y
My grill would not work once these were installed
I purchased these because my old ones were falling apart, they were easy to install but my grill would not light after they were installed.
Trustpilot
5 days ago
1 week ago
