Amax LightingLED-SL27BZ LED Security Light Wall Pack, 27W, Bronze

Had the same enclosure with the CFL pin base bulb, somewhat the same amount of light although way more powerful.Mounted up at about 12ft and it throws enough light to cover 25t of the a double wide driveway in strong light, while still able to offer good light out another 20ft. The stated 4000 Kelvin is White, just bordering on giving Blue. It's more for commercial building security, not any inviting warm tones. I now might not have considered for my residential neighborhood, the CFL did okay but these LED have their drawbacks.Two things I don't care for; it seems to bath the neighbors across the street (125ft away) with and eerie glow, and it is exceptionally intensive when driving up the street. Would almost work better if it was a 1ft square box that pointed down, would probably give the same light on the drive, but not push so much light out on the neighbors or not be so intensive just looking right at it.

They are light weight and a bit cheesy but the lighting performance is very good. From a distance they look exactly like my old expensive hps lights. I installed 7 last winter (Anchorage, Alaska) and they have performed flawlessly. I hope to get 5 years out of them. If I didn't have 58 exterior lights I might buy something nicer. For me it's all about function to cost ratio. Lights are not in any way serviceable. When they fail they go in the trash.

I am very disappointed in this fixture. This fixture will only work if the electric box to which it is connected is set into the wall (flush) so the lamp can be flat against the wall and caulked to the wall around the entire back side. Many barns, sheds, and brick structures have surface-mounted electric boxes, and this unit will not work on those because there is no way to seal the back against moisture or bugs.The unit has numerous openings in the back, and this allows insects, moisture and so forth to enter the light chamber unless it is flat against a wall. Moreover, the clear lens does not seal tightly against the brown frame (there is no gasket provided). Moreover, the only recommended attachment is by a threaded pipe which inserts into the back of the unit from the electric box. If the unit is not caulked to the wall, it will rotate around that pipe and not be stable.In addition to the aforementioned problems, my unit caused the GFIC fuse to trigger, so it has a current leak into the ground. THIS UNIT DOES NOT BEAR THE UNDERWRITER'S LABORATORY (UL) SYMBOL. The entire exterior is made of plastic. I will have to discard my unit and purchase a different brand. Wasted $60.

A good unit that works great, puts out a lot of light, but again mounting base all plastic

So after a little research, this product is not UL listed. It it not water tight and therefore does not meet National Electrial Codes to be mounted in a wet location.It is also not a wall pack as there are no conduit ports for installing power.I am also not ok with a 20% restocking fee as you have not listed your product with full disclosure to me on the listing. I would have not bought the item if I knew it was not a true wall pack and not meant for exterior wet locations and misleading the buyer.And no where does it state there is a 20% restocking fee. So now I'm out shipping and a restocking fee because the add was not 100% truthful. Waste of time

This light is very bright! It is in easy install. My attached picture is blurry but you can see how bright it is.

Very nice and does what it's supposed to. Good price and doesn't take many watts

Twice the lumens, half the price, what a deal, but it is NOT a wall pack. This is an inside light only. The electronics compartment has a least 27 holes through which water can get inside. (Caulking is not an acceptable solution.) And the lens does not have a seal around it. It is designed to mount on a junction box. It cannot interface with conduit from the bottom or back. Too bad, I love the light intensity.