JOUNJIP Plastic Welding Kit Deluxe -UL Certified Plastic Welder 80W Iron- Professional Grade Plastic Repair Kit for Automotive Car Bumper, Kayak, Tank Repair

I wanted to take the time to write a review for this product because it truly saved me a lot of time and money. I have a water buffalo on my work truck that had developed a hole in it and it had been repaired previously but the old repair was failing. I found this product and watched a few videos and decided to give it a try.With this product, I was able to EASILY repair the water buffalo for under $40! The cost to replace the tank would have been $900 or more. I am so impressed with the ease of use and the quality of the repair.The box for this product has photos of the family and a story about their small business you are supporting when you buy this product which were just an added bonus!If you're on the fence, watch a few videos to get familiar with what you're buying and try it for yourself!

Great service matters. When the iron failed to heat after about 2 hours of use, I thought I was out of luck being past 30 days since purchase. Then I noticed the phone number for service on the side of the box. I texted and got a phone call back within an hour. They are sending me a replacement tomorrow. Amazing service in these days of robots.

Product works well, but you have to know what to do before you buy this product, or u will become frustrated

This is excellent. I got a cheaper one at first and it didn’t heat up enough. The difference with this was night and day. Great quality!

I've already found several use cases for this tool and the materials included with it. There is definitely a learning curve to properly weld repair. Point of advice would be always use some reinforcement whether the included metal screen or staples or also steel wool works great too. Also would recommend to do outside for ventilation purposes. This product has already paid for itself in money saved from repairs.

It worked well for a hole I had in the newly replaced engine splash shield. I used the screen, aluminum tape, and the plastic rods to plastic weld the hole. I just need to do some sanding, then a quick application of a little black flat paint on it.

I used this for the first time today and I was surprised at the strength of the repair. This works much better than the hot staples I'd used on previous repairs. However, the brass tip on my welder became very soft as I was using it. The brass tip is threaded, and screws into the handle where heat is applied. The threads became so soft that the shaft with the threads began to elongate slightly. I'd screwed the tip into the welder until there was no gap between the two, but as I used it, a gap began to form on one side of the tip. I then noticed it was angled slightly. So, I used the welder to apply pressure from the opposite side to bend the tip back into alignment. This happened a couple of times over the ten minutes I used it. Then, the tip suddenly and completely broke off, leaving the threaded shaft inside the welder. This welder is so effective and useful that I plan to purchase a replacement. I'm not happy with the durability of the brass tips, but otherwise it does what it's supposed to do.

It works and i have hours of use out of it. I even used it to cut the inside out of a formed dewalt tool case. It is a hot item!