Instruction/How to Use First, gas-filled 1. Use high-quality gas to fill, and confirm the switch status is off. 2. Put The gas tank into the hole, press to fill. 3. Gas full-filled will take about 10 seconds, wait a few minutes, make sure the gas is stable,then use it to work. 4. if you heard hissing sound from the bottom,press the hole with the tip head,the can Eliminate the sound. Second, the ignition 1. Push the switch to the open place, and heard the hissing sound, 2. Ignite the place with the lighter near the joint. 3. adjust to On,the fire will get strong,adjust to off,the fire will get weak 4. the temperature up to 1300 ° C, you should be care when using it,and make use the status is off if you dont use it. 5. When using the gas soldering iron, wait until the flame is completely extinguished, the object inside get Red-hot, and then start to operate, the flame size should not be too large to extend the life of the tip. 6. The length of the flame is about 1.5-2.5 cm Precautions 1. Replace the connector, please wait after cooling or replace it in advance. 2. Use the tip, high temperature and hot, do not touch by hand 3. the adjustable botton can control the gas and temperature, just place it at the middle position. 4. do not put it in high temperature or direct sunlight. 5. Children are not allowed to use this product. 6. Please use high-quality canned gas filling, filling away from the fire source. 7. Because the gas is more or less some impurities, to always clean the nozzle 8. When cleaning, the nozzle can be cleaned by pressing the jet on the gas outlet. 9. Avoid heavy throw 10. Do not disassemble or repair in any case Model: MT-100 Filling capacity: 8ml Temperature: Flame temperature 1300 ° C, tip temperature 450 ° C Material: Plastic Fuel: pure butane
Trustpilot
1 month ago
1 month ago
